100% Latest & Updated Fortinet NSE4_FGT_AD-7.6 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 440
A security policy requires rekeying protected traffic periodically. Which protocol mechanism provides this?
- Check phase 2 selectors, encryption/integrity and PFS agreement on both peers.
- Configure supported phase 2 SA lifetime and rekey behavior.
- Confirm the peers use the same intended preshared key and compatible peer identities.
- Align the supported IKE version on both endpoints.
Explanation
Correct Answer
B:Traffic SAs are refreshed when their negotiated lifetime conditions require it.
Incorrect Answers
A:Phase 2 negotiates the selectors and cryptographic parameters for protected payload traffic; traffic SAs are refreshed when their negotiated lifetime conditions require it.
C:PSK mismatch prevents successful peer authentication. That distinction matters here because traffic SAs are refreshed when their negotiated lifetime conditions require it.
D:Peers must negotiate through a mutually supported IKE exchange protocol. For the condition in the stem, the necessary distinction is: Traffic SAs are refreshed when their negotiated lifetime conditions require it.
Question 441
An IPsec peer sits behind NAT and ordinary ESP traffic cannot be mapped correctly. Which mechanism should be enabled?
- Verify NAT discovery and UDP/4500 encapsulation eligibility between peers.
- Configure Dead Peer Detection for appropriate idle or on-demand peer checking.
- Use DPD settings that balance probe overhead against peer-loss detection time.
- Enable NAT traversal to carry ESP through UDP encapsulation.
Explanation
Correct Answer
D:NAT-T allows NAT gateways to maintain distinct IPsec sessions using UDP ports.
Incorrect Answers
A:NAT traversal commonly changes ESP transport to a UDP-carried form, whereas nAT-T allows NAT gateways to maintain distinct IPsec sessions using UDP ports.
B:DPD can identify unavailable IKE peers and clean up dead negotiation state. That distinction matters here because nAT-T allows NAT gateways to maintain distinct IPsec sessions using UDP ports.
C:Less frequent peer checks can delay recovery from a dead tunnel endpoint. For the condition in the stem, the necessary distinction is: NAT-T allows NAT gateways to maintain distinct IPsec sessions using UDP ports.
Question 442
A NAT device times out idle UDP mappings for an IPsec tunnel. What keepalive feature helps?
- Use DPD settings that balance probe overhead against peer-loss detection time.
- Verify NAT discovery and UDP/4500 encapsulation eligibility between peers.
- Configure NAT-T keepalives with an interval suitable for the NAT mapping lifetime.
- Enable NAT traversal to carry ESP through UDP encapsulation.
Explanation
Correct Answer
C:Periodic keepalives reduce idle deletion of the UDP translation used by the tunnel.
Incorrect Answers
A:Less frequent peer checks can delay recovery from a dead tunnel endpoint. That distinction matters here because periodic keepalives reduce idle deletion of the UDP translation used by the tunnel.
B:NAT traversal commonly changes ESP transport to a UDP-carried form. For the condition in the stem, the necessary distinction is: Periodic keepalives reduce idle deletion of the UDP translation used by the tunnel.
D:NAT-T allows NAT gateways to maintain distinct IPsec sessions using UDP ports; periodic keepalives reduce idle deletion of the UDP translation used by the tunnel.
Question 443
A branch peer powers off, but the firewall treats its IKE SA as alive for too long. What feature helps detect failure?
- Configure NAT-T keepalives with an interval suitable for the NAT mapping lifetime.
- Enable NAT traversal to carry ESP through UDP encapsulation.
- Use DPD settings that balance probe overhead against peer-loss detection time.
- Configure Dead Peer Detection for appropriate idle or on-demand peer checking.
Explanation
Correct Answer
D:DPD can identify unavailable IKE peers and clean up dead negotiation state.
Incorrect Answers
A:Periodic keepalives reduce idle deletion of the UDP translation used by the tunnel. For the condition in the stem, the necessary distinction is: DPD can identify unavailable IKE peers and clean up dead negotiation state.
B:NAT-T allows NAT gateways to maintain distinct IPsec sessions using UDP ports. DPD can identify unavailable IKE peers and clean up dead negotiation state.
C:Less frequent peer checks can delay recovery from a dead tunnel endpoint; dPD can identify unavailable IKE peers and clean up dead negotiation state.
Question 444
A VPN works without NAT but fails once a provider inserts a NAT gateway. What transport behavior should be checked?
- Configure NAT-T keepalives with an interval suitable for the NAT mapping lifetime.
- Enable NAT traversal to carry ESP through UDP encapsulation.
- Configure Dead Peer Detection for appropriate idle or on-demand peer checking.
- Verify NAT discovery and UDP/4500 encapsulation eligibility between peers.
Explanation
Correct Answer
D:NAT traversal commonly changes ESP transport to a UDP-carried form.
Incorrect Answers
A:Periodic keepalives reduce idle deletion of the UDP translation used by the tunnel. NAT traversal commonly changes ESP transport to a UDP-carried form.
B:NAT-T allows NAT gateways to maintain distinct IPsec sessions using UDP ports; nAT traversal commonly changes ESP transport to a UDP-carried form.
C:DPD can identify unavailable IKE peers and clean up dead negotiation state, whereas nAT traversal commonly changes ESP transport to a UDP-carried form.
Question 445
The operator disables DPD to reduce probes and now failover waits on stale peer state. What tradeoff matters?
- Configure Dead Peer Detection for appropriate idle or on-demand peer checking.
- Verify NAT discovery and UDP/4500 encapsulation eligibility between peers.
- Configure NAT-T keepalives with an interval suitable for the NAT mapping lifetime.
- Use DPD settings that balance probe overhead against peer-loss detection time.
Explanation
Correct Answer
D:Less frequent peer checks can delay recovery from a dead tunnel endpoint.
Incorrect Answers
A:DPD can identify unavailable IKE peers and clean up dead negotiation state; less frequent peer checks can delay recovery from a dead tunnel endpoint.
B:NAT traversal commonly changes ESP transport to a UDP-carried form, whereas less frequent peer checks can delay recovery from a dead tunnel endpoint.
C:Periodic keepalives reduce idle deletion of the UDP translation used by the tunnel. That distinction matters here because less frequent peer checks can delay recovery from a dead tunnel endpoint.
Question 446
A site-to-site IKE tunnel is established but routed packets bypass it through the default Internet path. What is missing?
- Configure symmetric return routing for the remote protected subnet through the tunnel.
- Disable inappropriate source NAT on the intersite policy or update the design's selectors consistently.
- Align compatible phase 2 traffic selectors for the intended protected networks.
- Add or correct the destination route through the route-based IPsec interface.
Explanation
Correct Answer
D:Phase negotiation alone does not choose a forwarding path for protected subnets.
Incorrect Answers
A:The reply path must reach the correct IPsec security association, whereas phase negotiation alone does not choose a forwarding path for protected subnets.
B:Unplanned SNAT can make packet addresses incompatible with negotiated tunnel selectors. That distinction matters here because phase negotiation alone does not choose a forwarding path for protected subnets.
C:Both peers must negotiate mutually compatible encrypted traffic selectors. For the condition in the stem, the necessary distinction is: Phase negotiation alone does not choose a forwarding path for protected subnets.
Question 447
A route sends traffic through the IPsec interface but the firewall denies new sessions. What second control is required?
- Configure symmetric return routing for the remote protected subnet through the tunnel.
- Create accepting policies between the LAN interface and the IPsec tunnel interface.
- Add or correct the destination route through the route-based IPsec interface.
- Disable inappropriate source NAT on the intersite policy or update the design's selectors consistently.
Explanation
Correct Answer
B:IPsec path selection and transit policy authorization are distinct gates.
Incorrect Answers
A:The reply path must reach the correct IPsec security association. That distinction matters here because iPsec path selection and transit policy authorization are distinct gates.
C:Phase negotiation alone does not choose a forwarding path for protected subnets. IPsec path selection and transit policy authorization are distinct gates.
D:Unplanned SNAT can make packet addresses incompatible with negotiated tunnel selectors; iPsec path selection and transit policy authorization are distinct gates.
Question 448
Peers have different phase 2 local and remote subnets, preventing child SA setup. What should agree?
- Align compatible phase 2 traffic selectors for the intended protected networks.
- Disable inappropriate source NAT on the intersite policy or update the design's selectors consistently.
- Add or correct the destination route through the route-based IPsec interface.
- Create accepting policies between the LAN interface and the IPsec tunnel interface.
Explanation
Correct Answer
A:Both peers must negotiate mutually compatible encrypted traffic selectors.
Incorrect Answers
B:Unplanned SNAT can make packet addresses incompatible with negotiated tunnel selectors. Both peers must negotiate mutually compatible encrypted traffic selectors.
C:Phase negotiation alone does not choose a forwarding path for protected subnets; both peers must negotiate mutually compatible encrypted traffic selectors.
D:IPsec path selection and transit policy authorization are distinct gates, whereas both peers must negotiate mutually compatible encrypted traffic selectors.
Question 449
A tunnel exists, but server replies are routed to an ISP instead of back into the VPN. What design should be corrected?
- Align compatible phase 2 traffic selectors for the intended protected networks.
- Configure symmetric return routing for the remote protected subnet through the tunnel.
- Add or correct the destination route through the route-based IPsec interface.
- Create accepting policies between the LAN interface and the IPsec tunnel interface.
Explanation
Correct Answer
B:The reply path must reach the correct IPsec security association.
Incorrect Answers
A:Both peers must negotiate mutually compatible encrypted traffic selectors. The reply path must reach the correct IPsec security association.
C:Phase negotiation alone does not choose a forwarding path for protected subnets, whereas the reply path must reach the correct IPsec security association.
D:IPsec path selection and transit policy authorization are distinct gates. That distinction matters here because the reply path must reach the correct IPsec security association.
Question 450
A VPN policy is mistakenly SNATing local traffic and the remote peer expects real protected subnets. What should be tested?
- Configure symmetric return routing for the remote protected subnet through the tunnel.
- Create accepting policies between the LAN interface and the IPsec tunnel interface.
- Disable inappropriate source NAT on the intersite policy or update the design's selectors consistently.
- Align compatible phase 2 traffic selectors for the intended protected networks.
Explanation
Correct Answer
C:Unplanned SNAT can make packet addresses incompatible with negotiated tunnel selectors.
Incorrect Answers
A:The reply path must reach the correct IPsec security association; unplanned SNAT can make packet addresses incompatible with negotiated tunnel selectors.
B:IPsec path selection and transit policy authorization are distinct gates, whereas unplanned SNAT can make packet addresses incompatible with negotiated tunnel selectors.
D:Both peers must negotiate mutually compatible encrypted traffic selectors. For the condition in the stem, the necessary distinction is: Unplanned SNAT can make packet addresses incompatible with negotiated tunnel selectors.
Fortinet NSE 4 - FortiOS 7.6 Administrator (NSE4_FGT_AD-7.6) Practice Tests