100% Latest & Updated Juniper JN0-364 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 420
An LDP neighbor appears in discovery output but no usable label bindings reach the next-hop interface. Independently, the review flags the potentially unsafe practice “Declare the service restored because the TCP LDP session is Established”. Which validation addresses the risk without assuming a particular cause?
- Inspect LDP database and label binding for the specific FEC
- Advertise a loopback transport address unreachable through the IGP
- Inspect LDP discovery adjacency on both link ends
- Inspect MPLS forwarding table and test LDP-carried traffic
Explanation
Correct Answer
D:Session state alone does not establish all labels or payload forwarding. Label distribution must translate into usable forwarding state.
Incorrect Answers
A:LDP associates advertised labels with forwarding equivalence classes.
B:Transport unreachability prevents reliable LDP session establishment.
C:LDP neighbors discover one another on configured interfaces.
Question 421
A service-provider ingress needs a specified MPLS path around a congested core hop instead of relying only on IGP shortest path. The objective is to configure RSVP-capable interfaces. Which Junos configuration or design action best satisfies the objective?
- Enable MPLS and RSVP on the required transit interfaces for the LSP
- Ignore all TE bandwidth availability while requesting a protected reservation
- Mark the LSP Up as soon as its configuration is accepted
- Assume RSVP-TE always follows the normal IP next hop without regard to path constraints
Explanation
Correct Answer
A:RSVP-signaled paths require compatible signaling along the route.
Incorrect Answers
B:A reservation request must fit the path's available resources.
C:A valid stanza may signal no working RSVP path.
D:Configured path constraints can change the chosen LSP route.
Question 422
A service-provider ingress needs a specified MPLS path around a congested core hop instead of relying only on IGP shortest path. The objective is to understand explicit route object. Which operational choice should be prioritized in this design?
- Ignore all TE bandwidth availability while requesting a protected reservation
- Use a suitable explicit path or constrained path selection for intended route steering
- Configure RSVP only at the ingress while all transit routers lack RSVP
- Mark the LSP Up as soon as its configuration is accepted
Explanation
Correct Answer
B:An ERO or CSPF policy can steer RSVP LSPs off the pure IGP shortest path.
Incorrect Answers
A:A reservation request must fit the path's available resources.
C:Missing transit signaling blocks an RSVP-TE path.
D:A valid stanza may signal no working RSVP path.
Question 423
A service-provider ingress needs a specified MPLS path around a congested core hop instead of relying only on IGP shortest path. The objective is to check bandwidth feasibility. Which routing or switching control best fits the requirement?
- Assume RSVP-TE always follows the normal IP next hop without regard to path constraints
- Compare configured reservations against available reservable bandwidth on each hop
- Mark the LSP Up as soon as its configuration is accepted
- Configure RSVP only at the ingress while all transit routers lack RSVP
Explanation
Correct Answer
B:Insufficient available TE resources can prevent setup.
Incorrect Answers
A:Configured path constraints can change the chosen LSP route.
C:A valid stanza may signal no working RSVP path.
D:Missing transit signaling blocks an RSVP-TE path.
Question 424
A service-provider ingress needs a specified MPLS path around a congested core hop instead of relying only on IGP shortest path. The objective is to verify signaled LSP state. Which verification should be performed before approving the change?
- Configure RSVP only at the ingress while all transit routers lack RSVP
- Assume RSVP-TE always follows the normal IP next hop without regard to path constraints
- Use show mpls lsp extensive and RSVP session output before routing production traffic
- Ignore all TE bandwidth availability while requesting a protected reservation
Explanation
Correct Answer
C:Successful LSP signaling is separate from mere configuration syntax.
Incorrect Answers
A:Missing transit signaling blocks an RSVP-TE path.
B:Configured path constraints can change the chosen LSP route.
D:A reservation request must fit the path's available resources.
Question 425
A service-provider ingress needs a specified MPLS path around a congested core hop instead of relying only on IGP shortest path. Two objectives apply: (1) configure RSVP-capable interfaces; and (2) check bandwidth feasibility. Which TWO controls together satisfy the requirements? Choose TWO.
- Ignore all TE bandwidth availability while requesting a protected reservation
- Assume RSVP-TE always follows the normal IP next hop without regard to path constraints
- Configure RSVP only at the ingress while all transit routers lack RSVP
- Compare configured reservations against available reservable bandwidth on each hop
- Enable MPLS and RSVP on the required transit interfaces for the LSP
Explanation
Correct Answers
D:Insufficient available TE resources can prevent setup.
E:RSVP-signaled paths require compatible signaling along the route.
Incorrect Answers
A:A reservation request must fit the path's available resources.
B:Configured path constraints can change the chosen LSP route.
C:Missing transit signaling blocks an RSVP-TE path.
Question 426
A service-provider ingress needs a specified MPLS path around a congested core hop instead of relying only on IGP shortest path. Three objectives apply: (1) configure RSVP-capable interfaces; (2) check bandwidth feasibility; and (3) verify signaled LSP state. Which THREE controls together satisfy the requirements? Choose THREE.
- Assume RSVP-TE always follows the normal IP next hop without regard to path constraints
- Configure RSVP only at the ingress while all transit routers lack RSVP
- Compare configured reservations against available reservable bandwidth on each hop
- Use show mpls lsp extensive and RSVP session output before routing production traffic
- Enable MPLS and RSVP on the required transit interfaces for the LSP
- Ignore all TE bandwidth availability while requesting a protected reservation
Explanation
Correct Answers
C:Insufficient available TE resources can prevent setup.
D:Successful LSP signaling is separate from mere configuration syntax.
E:RSVP-signaled paths require compatible signaling along the route.
Incorrect Answers
A:Configured path constraints can change the chosen LSP route.
B:Missing transit signaling blocks an RSVP-TE path.
F:A reservation request must fit the path's available resources.
Question 427
A new RSVP-TE LSP fails to signal after the operator includes a transit link with insufficient reservable bandwidth. Independently, the review flags the potentially unsafe practice “Configure RSVP only at the ingress while all transit routers lack RSVP”. Which inspection best evaluates that practice?
- Inspect RSVP admission failure and TE database link bandwidth
- Assume RSVP-TE always follows the normal IP next hop without regard to path constraints
- Inspect LSP operational state and reservation path
- Inspect MPLS and RSVP interface participation hop by hop
Explanation
Correct Answer
D:Missing transit signaling blocks an RSVP-TE path. RSVP-signaled paths require compatible signaling along the route.
Incorrect Answers
A:Insufficient available TE resources can prevent setup.
B:Configured path constraints can change the chosen LSP route.
C:Successful LSP signaling is separate from mere configuration syntax.
Question 428
A new RSVP-TE LSP fails to signal after the operator includes a transit link with insufficient reservable bandwidth. Independently, the review flags the potentially unsafe practice “Assume RSVP-TE always follows the normal IP next hop without regard to path constraints”. Which evidence most directly tests the flagged assumption?
- Inspect LSP operational state and reservation path
- Configure RSVP only at the ingress while all transit routers lack RSVP
- Inspect RSVP admission failure and TE database link bandwidth
- Inspect recorded route and requested ERO for the LSP
Explanation
Correct Answer
D:Configured path constraints can change the chosen LSP route. An ERO or CSPF policy can steer RSVP LSPs off the pure IGP shortest path.
Incorrect Answers
A:Successful LSP signaling is separate from mere configuration syntax.
B:Missing transit signaling blocks an RSVP-TE path.
C:Insufficient available TE resources can prevent setup.
Question 429
A new RSVP-TE LSP fails to signal after the operator includes a transit link with insufficient reservable bandwidth. Independently, the review flags the potentially unsafe practice “Ignore all TE bandwidth availability while requesting a protected reservation”. Which diagnostic check tests this potentially unsafe choice?
- Configure RSVP only at the ingress while all transit routers lack RSVP
- Inspect LSP operational state and reservation path
- Inspect recorded route and requested ERO for the LSP
- Inspect RSVP admission failure and TE database link bandwidth
Explanation
Correct Answer
D:A reservation request must fit the path's available resources. Insufficient available TE resources can prevent setup.
Incorrect Answers
A:Missing transit signaling blocks an RSVP-TE path.
B:Successful LSP signaling is separate from mere configuration syntax.
C:An ERO or CSPF policy can steer RSVP LSPs off the pure IGP shortest path.
Question 430
A new RSVP-TE LSP fails to signal after the operator includes a transit link with insufficient reservable bandwidth. Independently, the review flags the potentially unsafe practice “Mark the LSP Up as soon as its configuration is accepted”. Which validation addresses the risk without assuming a particular cause?
- Configure RSVP only at the ingress while all transit routers lack RSVP
- Inspect LSP operational state and reservation path
- Inspect recorded route and requested ERO for the LSP
- Inspect RSVP admission failure and TE database link bandwidth
Explanation
Correct Answer
B:A valid stanza may signal no working RSVP path. Successful LSP signaling is separate from mere configuration syntax.
Incorrect Answers
A:Missing transit signaling blocks an RSVP-TE path.
C:An ERO or CSPF policy can steer RSVP LSPs off the pure IGP shortest path.
D:Insufficient available TE resources can prevent setup.
Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-364) Practice Tests