100% Latest & Updated Cisco 350-901 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 10
A nightly playbook unexpectedly reports VLAN changes on every run even though the required segment is already present. Independently, reviewers flag this potentially unsafe practice for assessment: 'Interpret a successful task exit as proof all VLANs were correctly applied'. Which verification addresses that practice without assuming it caused the incident?
- Compare resource module arguments with VLAN operational state
- Run the play against every device discovered on the Internet
- Review second-run changes and per-device VLAN readback
- Audit variable sources, repository history and log redaction
Explanation
Correct Answer
C:Execution success alone does not establish intended state. The intended behavior is: Convergence is evidenced by configuration state and change reports.
Incorrect Answers
A:This checks make desired VLAN state explicit, not the named failure. Declarative resources allow repeated convergence to the desired state.
B:Unbounded targeting expands configuration blast radius.
D:This checks protect management credentials, not the named failure. Secrets should not be committed in plain playbooks or logs.
Question 11
A service-provider edge team must add three approved interfaces to OSPF area 0 without altering any other routing process. The specific implementation objective is to select correct routing instance. Which configuration best meets the stated requirement?
- Target the device-specific OSPF process and VRF from the inventory and source of truth
- Treat a successful SSH connection as evidence of OSPF convergence
- Skip all neighbor baseline collection because the playbook parses
- Configure all interfaces in area zero with no approval boundary
Explanation
Correct Answer
A:Routing context and process IDs are not interchangeable.
Incorrect Answers
B:Transport connectivity says nothing about protocol state.
C:Syntax validation does not prove routing continuity.
D:Overly broad OSPF participation exposes unwanted adjacencies.
Question 12
A service-provider edge team must add three approved interfaces to OSPF area 0 without altering any other routing process. The specific implementation objective is to apply scoped interface settings. Which design action is most appropriate for this case?
- Set the approved interfaces and area through supported network-resource models
- Treat a successful SSH connection as evidence of OSPF convergence
- Apply the same OSPF process identifier blindly to every tenant VRF
- Skip all neighbor baseline collection because the playbook parses
Explanation
Correct Answer
A:Explicit interface membership avoids changing neighboring links.
Incorrect Answers
B:Transport connectivity says nothing about protocol state.
C:Context mismatch can disrupt unrelated routing adjacencies.
D:Syntax validation does not prove routing continuity.
Question 13
A service-provider edge team must add three approved interfaces to OSPF area 0 without altering any other routing process. The specific implementation objective is to check routing safety. What should the engineer implement for this specific objective?
- Apply the same OSPF process identifier blindly to every tenant VRF
- Treat a successful SSH connection as evidence of OSPF convergence
- Validate proposed process/interface changes and neighbor impact before applying
- Configure all interfaces in area zero with no approval boundary
Explanation
Correct Answer
C:Prevalidation detects area and authentication mismatches early.
Incorrect Answers
A:Context mismatch can disrupt unrelated routing adjacencies.
B:Transport connectivity says nothing about protocol state.
D:Overly broad OSPF participation exposes unwanted adjacencies.
Question 14
A service-provider edge team must add three approved interfaces to OSPF area 0 without altering any other routing process. The specific implementation objective is to confirm post-change convergence. Which adjustment would satisfy this particular constraint?
- Apply the same OSPF process identifier blindly to every tenant VRF
- Skip all neighbor baseline collection because the playbook parses
- Check expected OSPF neighbors and route table after deployment
- Configure all interfaces in area zero with no approval boundary
Explanation
Correct Answer
C:Both adjacency and resulting routes must match design.
Incorrect Answers
A:Context mismatch can disrupt unrelated routing adjacencies.
B:Syntax validation does not prove routing continuity.
D:Overly broad OSPF participation exposes unwanted adjacencies.
Question 15
A service-provider edge team must add three approved interfaces to OSPF area 0 without altering any other routing process. The deployment plan must both (1) apply scoped interface settings and (2) confirm post-change convergence. Which TWO actions together satisfy those requirements? Choose TWO.
- Skip all neighbor baseline collection because the playbook parses
- Set the approved interfaces and area through supported network-resource models
- Check expected OSPF neighbors and route table after deployment
- Treat a successful SSH connection as evidence of OSPF convergence
- Apply the same OSPF process identifier blindly to every tenant VRF
Explanation
Correct Answers
B:Explicit interface membership avoids changing neighboring links.
C:Both adjacency and resulting routes must match design.
Incorrect Answers
A:Syntax validation does not prove routing continuity.
D:Transport connectivity says nothing about protocol state.
E:Context mismatch can disrupt unrelated routing adjacencies.
Question 16
A service-provider edge team must add three approved interfaces to OSPF area 0 without altering any other routing process. Three conditions must be met: (1) select correct routing instance; (2) check routing safety; and (3) confirm post-change convergence. Which THREE actions form the narrowest complete plan? Choose THREE.
- Skip all neighbor baseline collection because the playbook parses
- Check expected OSPF neighbors and route table after deployment
- Validate proposed process/interface changes and neighbor impact before applying
- Configure all interfaces in area zero with no approval boundary
- Target the device-specific OSPF process and VRF from the inventory and source of truth
- Treat a successful SSH connection as evidence of OSPF convergence
Explanation
Correct Answers
B:Both adjacency and resulting routes must match design.
C:Prevalidation detects area and authentication mismatches early.
E:Routing context and process IDs are not interchangeable.
Incorrect Answers
A:Syntax validation does not prove routing continuity.
D:Overly broad OSPF participation exposes unwanted adjacencies.
F:Transport connectivity says nothing about protocol state.
Question 17
A new edge interface has an OSPF neighbor problem after a broad playbook changed routing policy. Independently, reviewers flag this potentially unsafe practice for assessment: 'Apply the same OSPF process identifier blindly to every tenant VRF'. Which inspection most directly evaluates that practice?
- Capture neighbor baseline, authentication parameters and interface states
- Compare interface area assignments against the change record
- Treat a successful SSH connection as evidence of OSPF convergence
- Inspect process and VRF mappings against intended configuration
Explanation
Correct Answer
D:Context mismatch can disrupt unrelated routing adjacencies. The intended behavior is: Routing context and process IDs are not interchangeable.
Incorrect Answers
A:This checks check routing safety, not the named failure. Prevalidation detects area and authentication mismatches early.
B:This checks apply scoped interface settings, not the named failure. Explicit interface membership avoids changing neighboring links.
C:Transport connectivity says nothing about protocol state.
Question 18
A new edge interface has an OSPF neighbor problem after a broad playbook changed routing policy. Independently, reviewers flag this potentially unsafe practice for assessment: 'Configure all interfaces in area zero with no approval boundary'. What diagnostic evidence should first be collected to assess that practice?
- Treat a successful SSH connection as evidence of OSPF convergence
- Capture neighbor baseline, authentication parameters and interface states
- Inspect process and VRF mappings against intended configuration
- Compare interface area assignments against the change record
Explanation
Correct Answer
D:Overly broad OSPF participation exposes unwanted adjacencies. The intended behavior is: Explicit interface membership avoids changing neighboring links.
Incorrect Answers
A:Transport connectivity says nothing about protocol state.
B:This checks check routing safety, not the named failure. Prevalidation detects area and authentication mismatches early.
C:This checks select correct routing instance, not the named failure. Routing context and process IDs are not interchangeable.
Question 19
A new edge interface has an OSPF neighbor problem after a broad playbook changed routing policy. Independently, reviewers flag this potentially unsafe practice for assessment: 'Skip all neighbor baseline collection because the playbook parses'. Which focused check best tests this specific assumption?
- Compare interface area assignments against the change record
- Capture neighbor baseline, authentication parameters and interface states
- Compare OSPF neighbor and route outputs before and after
- Apply the same OSPF process identifier blindly to every tenant VRF
Explanation
Correct Answer
B:Syntax validation does not prove routing continuity. The intended behavior is: Prevalidation detects area and authentication mismatches early.
Incorrect Answers
A:This checks apply scoped interface settings, not the named failure. Explicit interface membership avoids changing neighboring links.
C:This checks confirm post-change convergence, not the named failure. Both adjacency and resulting routes must match design.
D:Context mismatch can disrupt unrelated routing adjacencies.
Question 20
A new edge interface has an OSPF neighbor problem after a broad playbook changed routing policy. Independently, reviewers flag this potentially unsafe practice for assessment: 'Treat a successful SSH connection as evidence of OSPF convergence'. Which verification addresses that practice without assuming it caused the incident?
- Apply the same OSPF process identifier blindly to every tenant VRF
- Compare interface area assignments against the change record
- Capture neighbor baseline, authentication parameters and interface states
- Compare OSPF neighbor and route outputs before and after
Explanation
Correct Answer
D:Transport connectivity says nothing about protocol state. The intended behavior is: Both adjacency and resulting routes must match design.
Incorrect Answers
A:Context mismatch can disrupt unrelated routing adjacencies.
B:This checks apply scoped interface settings, not the named failure. Explicit interface membership avoids changing neighboring links.
C:This checks check routing safety, not the named failure. Prevalidation detects area and authentication mismatches early.
Designing, Deploying, and Managing Network Automation Systems (350-901) Practice Tests