100% Latest & Updated HP HPE7-A11 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 170
A single-building campus has 720 wired endpoints across eight closets and proposes one 48-port access switch per closet. Which next design step best resolves the identified problem?
- Size access blocks from measured per-closet endpoints, port types, uplinks and growth, then connect to a suitable redundant collapsed core.
- Add multicast sender, receiver VLANs, routers and snooping or filtering boundaries to the service flow.
- Select compatible multigigabit access ports and sufficient upstream bandwidth after application analysis.
- Show independent gateway uplinks, aggregation paths and client tunnel ownership in the availability diagram.
Explanation
Correct Answer
A:The intervention addresses: The preliminary topology undercounts physical edge ports before spares and AP connections. Check effectiveness by: Reconcile the room-by-room port schedule against the preliminary equipment quantities.
Incorrect Answers
B:That alternative addresses a campus facing multicast distribution workflow. The stated requirement instead calls for: Size access blocks from measured per-closet endpoints, port types, uplinks and growth, then connect to a suitable redundant collapsed core.
C:That response could help in a separate multigig ap connection planning project, but it cannot establish the needed result here: Reconcile the room-by-room port schedule against the preliminary equipment quantities.
D:That response could help in a separate gateway redundancy data flow project, but it cannot establish the needed result here: Reconcile the room-by-room port schedule against the preliminary equipment quantities.
Question 171
A single-building campus has 720 wired endpoints across eight closets and proposes one 48-port access switch per closet. What verification would most directly confirm the design decision?
- Reconcile the room-by-room port schedule against the preliminary equipment quantities.
- Simulate approved management reachability loss and observe client forwarding and visibility separately.
- Check traffic captures or application tests against the proposed service paths under peak usage.
- Validate optical budget and receive levels on the installed OS2 link before acceptance.
Explanation
Correct Answer
A:Reconcile the room-by-room port schedule against the preliminary equipment quantities. This measures the intended design outcome, not just equipment power.
Incorrect Answers
B:That alternative addresses a campus facing cloud management connectivity. The stated requirement instead calls for: Size access blocks from measured per-closet endpoints, port types, uplinks and growth, then connect to a suitable redundant collapsed core.
C:That is relevant to application traffic classification, but this case is about two-tier port planning. The preliminary topology undercounts physical edge ports before spares and AP connections.
D:The alternative belongs to a campus facing fiber reach and optic compatibility. The stated requirement instead calls for: Size access blocks from measured per-closet endpoints, port types, uplinks and growth, then connect to a suitable redundant collapsed core.
Question 172
A single-building campus has 720 wired endpoints across eight closets and proposes one 48-port access switch per closet. Select THREE complementary steps covering the technical response, acceptance evidence and future control.
- Size access blocks from measured per-closet endpoints, port types, uplinks and growth, then connect to a suitable redundant collapsed core.
- Validate optical budget and receive levels on the installed OS2 link before acceptance.
- Reconcile the room-by-room port schedule against the preliminary equipment quantities.
- Record the oversubscription assumption and growth trigger for each access tier.
- Survey physical and electrical limits and revise switch form factor, rack or power design before procurement.
- Require closet-level port arithmetic and headroom evidence in every preliminary BoM.
Explanation
Correct Answers
A:Size access blocks from measured per-closet endpoints, port types, uplinks and growth, then connect to a suitable redundant collapsed core. Acceptance evidence: Reconcile the room-by-room port schedule against the preliminary equipment quantities.
C:This check tests the specific risk: The preliminary topology undercounts physical edge ports before spares and AP connections. A general health status is insufficient.
F:The recurring exposure is the preliminary topology undercounts physical edge ports before spares and AP connections. The proposed review practice catches regression of that specific assumption.
Incorrect Answers
B:The alternative belongs to a campus facing fiber reach and optic compatibility. The stated requirement instead calls for: Size access blocks from measured per-closet endpoints, port types, uplinks and growth, then connect to a suitable redundant collapsed core.
D:It targets uplink oversubscription review rather than the missing control in this design. The relevant safeguard is: Require closet-level port arithmetic and headroom evidence in every preliminary BoM.
E:That is relevant to idf rack and power constraints, but this case is about two-tier port planning. The preliminary topology undercounts physical edge ports before spares and AP connections.
Question 173
A university expects 16,000 concurrent devices across multiple buildings and chooses one shared aggregation pair for the entire site. What is the central risk exposed by this scenario?
- The design may centralize too many failure domains and interbuilding paths for the stated size.
- Two cables terminating on one physical switch do not remove that switch as a failure point.
- Roaming behavior depends on traffic anchoring and subnet boundaries that the current diagram omits.
- The functional topology retains a common failure point despite duplicate gateways.
Explanation
Correct Answer
A:The design may centralize too many failure domains and interbuilding paths for the stated size. The appropriate response is to evaluate a dedicated routed core with building aggregation blocks and appropriate service attachment.
Incorrect Answers
B:That response could help in a separate redundant aggregation links project, but it cannot establish the needed result here: Simulate an aggregation-block failure and observe only the intended building's service impact.
C:That alternative addresses a campus facing roaming domain mapping. The stated requirement instead calls for: Evaluate a dedicated routed core with building aggregation blocks and appropriate service attachment.
D:That response could help in a separate gateway redundancy data flow project, but it cannot establish the needed result here: Simulate an aggregation-block failure and observe only the intended building's service impact.
Question 174
A university expects 16,000 concurrent devices across multiple buildings and chooses one shared aggregation pair for the entire site. Which proposed response is most directly aligned with the evidence?
- Evaluate a dedicated routed core with building aggregation blocks and appropriate service attachment.
- Create a WAN failover workflow showing health probes, preferred routes, application priorities and convergence assumptions.
- Map Central connectivity, local forwarding dependencies and the site's outbound security constraints.
- Size access blocks from measured per-closet endpoints, port types, uplinks and growth, then connect to a suitable redundant collapsed core.
Explanation
Correct Answer
A:Evaluate a dedicated routed core with building aggregation blocks and appropriate service attachment. Acceptance evidence: Simulate an aggregation-block failure and observe only the intended building's service impact.
Incorrect Answers
B:It would address the different situation in dual-wan failover model; it does not resolve the stated design evidence. Here, the design may centralize too many failure domains and interbuilding paths for the stated size.
C:That option addresses cloud management connectivity, not this design gap. The needed safeguard is: Document the scaling trigger and failure-domain boundaries for future buildings.
D:That is relevant to two-tier port planning, but this case is about core separation at scale. The design may centralize too many failure domains and interbuilding paths for the stated size.
Question 175
A university expects 16,000 concurrent devices across multiple buildings and chooses one shared aggregation pair for the entire site. What would the customer need to observe before signing off?
- Trace an unauthorized attempt from guest space to a protected file server and confirm denial.
- Simulate an aggregation-block failure and observe only the intended building's service impact.
- Validate optical budget and receive levels on the installed OS2 link before acceptance.
- Remove the common switch in a test plan and observe the intended recovery outcome.
Explanation
Correct Answer
B:It examines whether the key risk has been controlled: The design may centralize too many failure domains and interbuilding paths for the stated size. A pass requires the specific behavior in this option, not a general health indicator.
Incorrect Answers
A:That option addresses guest-to-internet trust boundary, not this design gap. The needed safeguard is: Document the scaling trigger and failure-domain boundaries for future buildings.
C:That response could help in a separate fiber reach and optic compatibility project, but it cannot establish the needed result here: Simulate an aggregation-block failure and observe only the intended building's service impact.
D:That option addresses gateway redundancy data flow, not this design gap. The needed safeguard is: Document the scaling trigger and failure-domain boundaries for future buildings.
Question 176
A university expects 16,000 concurrent devices across multiple buildings and chooses one shared aggregation pair for the entire site. Select THREE complementary steps covering the technical response, acceptance evidence and future control.
- Choose a platform-supported single-mode optic with an adequate optical reach and matched connector requirements.
- Simulate an aggregation-block failure and observe only the intended building's service impact.
- Calculate 24 times 25 plus 12 times 10 and compare with usable supply and failover state.
- Evaluate a dedicated routed core with building aggregation blocks and appropriate service attachment.
- Include N-minus-one capacity and recovery time in the approved equipment schedule.
- Document the scaling trigger and failure-domain boundaries for future buildings.
Explanation
Correct Answers
B:It examines whether the key risk has been controlled: The design may centralize too many failure domains and interbuilding paths for the stated size. A pass requires the specific behavior in this option, not a general health indicator.
D:The intervention addresses: The design may centralize too many failure domains and interbuilding paths for the stated size. Verify with: Simulate an aggregation-block failure and observe only the intended building's service impact.
F:The recurring exposure is the design may centralize too many failure domains and interbuilding paths for the stated size. The proposed review practice catches regression of that specific assumption.
Incorrect Answers
A:That is relevant to fiber reach and optic compatibility, but this case is about core separation at scale. The design may centralize too many failure domains and interbuilding paths for the stated size.
C:It would address the different situation in poe wattage arithmetic; it does not resolve the stated design evidence. Here, the design may centralize too many failure domains and interbuilding paths for the stated size.
E:That option addresses gateway cluster capacity after failure, not this design gap. The needed safeguard is: Document the scaling trigger and failure-domain boundaries for future buildings.
Question 177
A ballroom hosts 1,200 simultaneous conference attendees, and an initial AP quote is based only on square footage. Which design issue is most directly shown by these facts?
- The preliminary topology undercounts physical edge ports before spares and AP connections.
- The policy method must accommodate non-supplicant devices without bypassing least privilege.
- The proposed layering may add cost and operational complexity without a scale or fault-domain need.
- Capacity, airtime and client distribution can be more restrictive than simple coverage area.
Explanation
Correct Answer
D:Capacity, airtime and client distribution can be more restrictive than simple coverage area. The appropriate response is to develop an RF and client-density plan using expected devices, applications, antenna placement and measured interference.
Incorrect Answers
A:It would address the different situation in two-tier port planning; it does not resolve the stated design evidence. Here, capacity, airtime and client distribution can be more restrictive than simple coverage area.
B:It would address the different situation in printer onboarding choice; it does not resolve the stated design evidence. Here, capacity, airtime and client distribution can be more restrictive than simple coverage area.
C:That alternative addresses a campus facing small-office campus topology. The stated requirement instead calls for: Develop an RF and client-density plan using expected devices, applications, antenna placement and measured interference.
Question 178
A ballroom hosts 1,200 simultaneous conference attendees, and an initial AP quote is based only on square footage. What action is most defensible within the stated constraints?
- Develop an RF and client-density plan using expected devices, applications, antenna placement and measured interference.
- Show independent gateway uplinks, aggregation paths and client tunnel ownership in the availability diagram.
- Select compatible multigigabit access ports and sufficient upstream bandwidth after application analysis.
- Draw DHCP discover, relay, scope and return paths for each intended client VLAN.
Explanation
Correct Answer
A:Develop an RF and client-density plan using expected devices, applications, antenna placement and measured interference. Acceptance evidence: Test busy-room client throughput and retry rates against the accepted occupancy profile.
Incorrect Answers
B:It would address the different situation in gateway redundancy data flow; it does not resolve the stated design evidence. Here, capacity, airtime and client distribution can be more restrictive than simple coverage area.
C:That is relevant to multigig ap connection planning, but this case is about ap count based on occupancy. Capacity, airtime and client distribution can be more restrictive than simple coverage area.
D:That response could help in a separate dhcp relay workflow project, but it cannot establish the needed result here: Test busy-room client throughput and retry rates against the accepted occupancy profile.
Question 179
A ballroom hosts 1,200 simultaneous conference attendees, and an initial AP quote is based only on square footage. Which test best distinguishes the proposed fix from a cosmetic change?
- Test busy-room client throughput and retry rates against the accepted occupancy profile.
- Disconnect one provider in a planned test and record which applications recover within their target windows.
- Check the selected switch model and software support for each stack or multi-chassis configuration.
- Simulate one gateway unavailable under busy traffic and confirm load stays within supported capacity.
Explanation
Correct Answer
A:Test busy-room client throughput and retry rates against the accepted occupancy profile. This measures the intended design outcome, not just equipment power.
Incorrect Answers
B:That is relevant to dual-wan failover model, but this case is about ap count based on occupancy. Capacity, airtime and client distribution can be more restrictive than simple coverage area.
C:That option addresses access stacking versus core pairing, not this design gap. The needed safeguard is: Keep capacity assumptions tied to event type and room reconfiguration.
D:That response could help in a separate gateway cluster capacity after failure project, but it cannot establish the needed result here: Test busy-room client throughput and retry rates against the accepted occupancy profile.
Question 180
A ballroom hosts 1,200 simultaneous conference attendees, and an initial AP quote is based only on square footage. Which process improvement fits the identified design exposure?
- Reassess management fit when the customer adds identity or segmentation requirements.
- Keep guest trust boundaries in security-design review, not only in cabling diagrams.
- Keep capacity assumptions tied to event type and room reconfiguration.
- Require facilities sign-off on rack elevation and electrical requirements with the final BoM.
Explanation
Correct Answer
C:This safeguard makes the control repeatable when the installation or requirements change. Keep capacity assumptions tied to event type and room reconfiguration.
Incorrect Answers
A:That option addresses small business management boundary, not this design gap. The needed safeguard is: Keep capacity assumptions tied to event type and room reconfiguration.
B:That is relevant to guest-to-internet trust boundary, but this case is about ap count based on occupancy. Capacity, airtime and client distribution can be more restrictive than simple coverage area.
D:That alternative addresses a campus facing idf rack and power constraints. The stated requirement instead calls for: Develop an RF and client-density plan using expected devices, applications, antenna placement and measured interference.
HPE Network Campus Access Professional Architect (HPE7-A11) Practice Tests