100% Latest & Updated Juniper JN0-364 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 150
Packet captures show database description exchanges repeat after a core router replacement, but an operator proposes adjusting only route preference. Independently, the review flags the potentially unsafe practice “Declare complete recovery as soon as one Hello packet is received”. Which validation addresses the risk without assuming a particular cause?
- Inspect neighbor state transitions and DBD exchange statistics
- Reuse one router ID across unrelated routers to simplify documentation
- Compare interface MTUs and OSPF exchange logs
- Compare post-repair LSDB and route table for missing prefixes
Explanation
Correct Answer
D:Hello receipt is earlier than complete database synchronization. Full state should be followed by correct prefix installation.
Incorrect Answers
A:ExStart and Exchange point to database negotiation problems.
B:Duplicate identities create control-plane ambiguity.
C:MTU differences can cause adjacency formation to stall.
Question 151
Two provider routers are joined across a regional boundary; one is Level 1 only and the other expects to exchange interarea routes at Level 2. The objective is to identify correct level role. Which Junos configuration or design action best satisfies the objective?
- Give two independent routers the same IS-IS system ID
- Assign Level 1 and Level 2 roles consistent with intraregional and interregional routing
- Assume Level 1 neighbors in arbitrary different areas always form adjacency
- Declare end-to-end routing correct because one local L1 neighbor is up
Explanation
Correct Answer
B:Level 1 and Level 2 distribute reachability at different scope.
Incorrect Answers
A:Duplicate system identities break reliable link-state interpretation.
C:Area mismatch blocks expected L1 operation.
D:Local adjacency does not establish remote area paths.
Question 152
Two provider routers are joined across a regional boundary; one is Level 1 only and the other expects to exchange interarea routes at Level 2. The objective is to verify NET area format. Which operational choice should be prioritized in this design?
- Configure every interarea transit as Level 1 only without an L2 path
- Assume Level 1 neighbors in arbitrary different areas always form adjacency
- Declare end-to-end routing correct because one local L1 neighbor is up
- Check system identifiers and area addresses in each router's NET
Explanation
Correct Answer
D:NET identity and area membership affect supported adjacencies.
Incorrect Answers
A:Level 1 alone cannot replace Level 2 interarea connectivity.
B:Area mismatch blocks expected L1 operation.
C:Local adjacency does not establish remote area paths.
Question 153
Two provider routers are joined across a regional boundary; one is Level 1 only and the other expects to exchange interarea routes at Level 2. The objective is to respect L1 area alignment. Which routing or switching control best fits the requirement?
- Declare end-to-end routing correct because one local L1 neighbor is up
- Keep Level 1-only adjacencies within compatible area addressing
- Configure every interarea transit as Level 1 only without an L2 path
- Give two independent routers the same IS-IS system ID
Explanation
Correct Answer
B:Level 1 neighbor formation requires appropriate common area identity.
Incorrect Answers
A:Local adjacency does not establish remote area paths.
C:Level 1 alone cannot replace Level 2 interarea connectivity.
D:Duplicate system identities break reliable link-state interpretation.
Question 154
Two provider routers are joined across a regional boundary; one is Level 1 only and the other expects to exchange interarea routes at Level 2. The objective is to confirm L2 reachability. Which verification should be performed before approving the change?
- Assume Level 1 neighbors in arbitrary different areas always form adjacency
- Configure every interarea transit as Level 1 only without an L2 path
- Give two independent routers the same IS-IS system ID
- Check that Level 2 topology connects the regional exit toward other areas
Explanation
Correct Answer
D:Interarea destinations need valid Level 2 reachability.
Incorrect Answers
A:Area mismatch blocks expected L1 operation.
B:Level 1 alone cannot replace Level 2 interarea connectivity.
C:Duplicate system identities break reliable link-state interpretation.
Question 155
Two provider routers are joined across a regional boundary; one is Level 1 only and the other expects to exchange interarea routes at Level 2. Two objectives apply: (1) verify NET area format; and (2) confirm L2 reachability. Which TWO controls together satisfy the requirements? Choose TWO.
- Declare end-to-end routing correct because one local L1 neighbor is up
- Check that Level 2 topology connects the regional exit toward other areas
- Assume Level 1 neighbors in arbitrary different areas always form adjacency
- Give two independent routers the same IS-IS system ID
- Check system identifiers and area addresses in each router's NET
Explanation
Correct Answers
B:Interarea destinations need valid Level 2 reachability.
E:NET identity and area membership affect supported adjacencies.
Incorrect Answers
A:Local adjacency does not establish remote area paths.
C:Area mismatch blocks expected L1 operation.
D:Duplicate system identities break reliable link-state interpretation.
Question 156
Two provider routers are joined across a regional boundary; one is Level 1 only and the other expects to exchange interarea routes at Level 2. Three objectives apply: (1) identify correct level role; (2) respect L1 area alignment; and (3) confirm L2 reachability. Which THREE controls together satisfy the requirements? Choose THREE.
- Configure every interarea transit as Level 1 only without an L2 path
- Check that Level 2 topology connects the regional exit toward other areas
- Keep Level 1-only adjacencies within compatible area addressing
- Give two independent routers the same IS-IS system ID
- Declare end-to-end routing correct because one local L1 neighbor is up
- Assign Level 1 and Level 2 roles consistent with intraregional and interregional routing
Explanation
Correct Answers
B:Interarea destinations need valid Level 2 reachability.
C:Level 1 neighbor formation requires appropriate common area identity.
F:Level 1 and Level 2 distribute reachability at different scope.
Incorrect Answers
A:Level 1 alone cannot replace Level 2 interarea connectivity.
D:Duplicate system identities break reliable link-state interpretation.
E:Local adjacency does not establish remote area paths.
Question 157
After adding a regional router, Level 1 neighbors remain reachable but advertised destinations outside the local area disappear. Independently, the review flags the potentially unsafe practice “Configure every interarea transit as Level 1 only without an L2 path”. Which inspection best evaluates that practice?
- Compare NET area and system-ID fields on both peers
- Declare end-to-end routing correct because one local L1 neighbor is up
- Inspect configured IS-IS levels and adjacent level states
- Review the area address in Hello PDUs and configured NETs
Explanation
Correct Answer
C:Level 1 alone cannot replace Level 2 interarea connectivity. Level 1 and Level 2 distribute reachability at different scope.
Incorrect Answers
A:NET identity and area membership affect supported adjacencies.
B:Local adjacency does not establish remote area paths.
D:Level 1 neighbor formation requires appropriate common area identity.
Question 158
After adding a regional router, Level 1 neighbors remain reachable but advertised destinations outside the local area disappear. Independently, the review flags the potentially unsafe practice “Give two independent routers the same IS-IS system ID”. Which evidence most directly tests the flagged assumption?
- Review the area address in Hello PDUs and configured NETs
- Inspect configured IS-IS levels and adjacent level states
- Declare end-to-end routing correct because one local L1 neighbor is up
- Compare NET area and system-ID fields on both peers
Explanation
Correct Answer
D:Duplicate system identities break reliable link-state interpretation. NET identity and area membership affect supported adjacencies.
Incorrect Answers
A:Level 1 neighbor formation requires appropriate common area identity.
B:Level 1 and Level 2 distribute reachability at different scope.
C:Local adjacency does not establish remote area paths.
Question 159
After adding a regional router, Level 1 neighbors remain reachable but advertised destinations outside the local area disappear. Independently, the review flags the potentially unsafe practice “Assume Level 1 neighbors in arbitrary different areas always form adjacency”. Which diagnostic check tests this potentially unsafe choice?
- Declare end-to-end routing correct because one local L1 neighbor is up
- Inspect configured IS-IS levels and adjacent level states
- Review the area address in Hello PDUs and configured NETs
- Compare NET area and system-ID fields on both peers
Explanation
Correct Answer
C:Area mismatch blocks expected L1 operation. Level 1 neighbor formation requires appropriate common area identity.
Incorrect Answers
A:Local adjacency does not establish remote area paths.
B:Level 1 and Level 2 distribute reachability at different scope.
D:NET identity and area membership affect supported adjacencies.
Question 160
After adding a regional router, Level 1 neighbors remain reachable but advertised destinations outside the local area disappear. Independently, the review flags the potentially unsafe practice “Declare end-to-end routing correct because one local L1 neighbor is up”. Which validation addresses the risk without assuming a particular cause?
- Review the area address in Hello PDUs and configured NETs
- Inspect L2 LSDB and remote prefix routes
- Inspect configured IS-IS levels and adjacent level states
- Give two independent routers the same IS-IS system ID
Explanation
Correct Answer
B:Local adjacency does not establish remote area paths. Interarea destinations need valid Level 2 reachability.
Incorrect Answers
A:Level 1 neighbor formation requires appropriate common area identity.
C:Level 1 and Level 2 distribute reachability at different scope.
D:Duplicate system identities break reliable link-state interpretation.
Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-364) Practice Tests