100% Latest & Updated Juniper JN0-364 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 160
After adding a regional router, Level 1 neighbors remain reachable but advertised destinations outside the local area disappear. Independently, the review flags the potentially unsafe practice “Declare end-to-end routing correct because one local L1 neighbor is up”. Which validation addresses the risk without assuming a particular cause?
- Review the area address in Hello PDUs and configured NETs
- Inspect L2 LSDB and remote prefix routes
- Inspect configured IS-IS levels and adjacent level states
- Give two independent routers the same IS-IS system ID
Explanation
Correct Answer
B:Local adjacency does not establish remote area paths. Interarea destinations need valid Level 2 reachability.
Incorrect Answers
A:Level 1 neighbor formation requires appropriate common area identity.
C:Level 1 and Level 2 distribute reachability at different scope.
D:Duplicate system identities break reliable link-state interpretation.
Question 161
A routed point-to-point core link is UP and carries pings but an IS-IS peer remains Down after a port migration. The objective is to confirm IS-IS interface membership. Which Junos configuration or design action best satisfies the objective?
- Assume an ordinary 64-byte ping verifies padded IS-IS PDU transport
- Treat a Level 2-only peer and Level 1-only peer as a guaranteed adjacency
- Enable IS-IS at the intended logical core interface and routing instance
- Declare success only because the remote host responds to ICMP
Explanation
Correct Answer
C:Physical link up is insufficient if routing protocol is not enabled there.
Incorrect Answers
A:Packet-size differences can impair adjacency.
B:Different level-only configurations may have no shared level.
D:ICMP reachability is not IS-IS database synchronization.
Question 162
A routed point-to-point core link is UP and carries pings but an IS-IS peer remains Down after a port migration. The objective is to compare peer circuit levels. Which operational choice should be prioritized in this design?
- Assume an ordinary 64-byte ping verifies padded IS-IS PDU transport
- Match supported IS-IS level and circuit-type settings at both ends
- Run IS-IS only on the management interface and assume core peers discover it
- Declare success only because the remote host responds to ICMP
Explanation
Correct Answer
B:Incompatible level settings prevent expected neighbor formation.
Incorrect Answers
A:Packet-size differences can impair adjacency.
C:Protocol must operate on the intended adjacency interface.
D:ICMP reachability is not IS-IS database synchronization.
Question 163
A routed point-to-point core link is UP and carries pings but an IS-IS peer remains Down after a port migration. The objective is to check MTU and padding. Which routing or switching control best fits the requirement?
- Declare success only because the remote host responds to ICMP
- Compare IS-IS PDU handling and MTU compatibility across the connection
- Run IS-IS only on the management interface and assume core peers discover it
- Treat a Level 2-only peer and Level 1-only peer as a guaranteed adjacency
Explanation
Correct Answer
B:Larger padded IS-IS hellos can fail despite small ping success.
Incorrect Answers
A:ICMP reachability is not IS-IS database synchronization.
C:Protocol must operate on the intended adjacency interface.
D:Different level-only configurations may have no shared level.
Question 164
A routed point-to-point core link is UP and carries pings but an IS-IS peer remains Down after a port migration. The objective is to verify neighbor and database exchange. Which verification should be performed before approving the change?
- Use show isis adjacency and database outputs after repair
- Treat a Level 2-only peer and Level 1-only peer as a guaranteed adjacency
- Run IS-IS only on the management interface and assume core peers discover it
- Assume an ordinary 64-byte ping verifies padded IS-IS PDU transport
Explanation
Correct Answer
A:A stable adjacency should accompany expected link-state information.
Incorrect Answers
B:Different level-only configurations may have no shared level.
C:Protocol must operate on the intended adjacency interface.
D:Packet-size differences can impair adjacency.
Question 165
A routed point-to-point core link is UP and carries pings but an IS-IS peer remains Down after a port migration. Two objectives apply: (1) confirm IS-IS interface membership; and (2) check MTU and padding. Which TWO controls together satisfy the requirements? Choose TWO.
- Run IS-IS only on the management interface and assume core peers discover it
- Compare IS-IS PDU handling and MTU compatibility across the connection
- Enable IS-IS at the intended logical core interface and routing instance
- Treat a Level 2-only peer and Level 1-only peer as a guaranteed adjacency
- Declare success only because the remote host responds to ICMP
Explanation
Correct Answers
B:Larger padded IS-IS hellos can fail despite small ping success.
C:Physical link up is insufficient if routing protocol is not enabled there.
Incorrect Answers
A:Protocol must operate on the intended adjacency interface.
D:Different level-only configurations may have no shared level.
E:ICMP reachability is not IS-IS database synchronization.
Question 166
A routed point-to-point core link is UP and carries pings but an IS-IS peer remains Down after a port migration. Three objectives apply: (1) compare peer circuit levels; (2) check MTU and padding; and (3) verify neighbor and database exchange. Which THREE controls together satisfy the requirements? Choose THREE.
- Run IS-IS only on the management interface and assume core peers discover it
- Declare success only because the remote host responds to ICMP
- Treat a Level 2-only peer and Level 1-only peer as a guaranteed adjacency
- Match supported IS-IS level and circuit-type settings at both ends
- Compare IS-IS PDU handling and MTU compatibility across the connection
- Use show isis adjacency and database outputs after repair
Explanation
Correct Answers
D:Incompatible level settings prevent expected neighbor formation.
E:Larger padded IS-IS hellos can fail despite small ping success.
F:A stable adjacency should accompany expected link-state information.
Incorrect Answers
A:Protocol must operate on the intended adjacency interface.
B:ICMP reachability is not IS-IS database synchronization.
C:Different level-only configurations may have no shared level.
Question 167
The NOC sees missing IS-IS neighbors despite physical links passing traffic and no reported Ethernet errors. Independently, the review flags the potentially unsafe practice “Run IS-IS only on the management interface and assume core peers discover it”. Which inspection best evaluates that practice?
- Compare adjacent interface circuit types and configured levels
- Inspect IS-IS interface configuration and operational state
- Declare success only because the remote host responds to ICMP
- Inspect PDU-size counters and MTU at both interfaces
Explanation
Correct Answer
B:Protocol must operate on the intended adjacency interface. Physical link up is insufficient if routing protocol is not enabled there.
Incorrect Answers
A:Incompatible level settings prevent expected neighbor formation.
C:ICMP reachability is not IS-IS database synchronization.
D:Larger padded IS-IS hellos can fail despite small ping success.
Question 168
The NOC sees missing IS-IS neighbors despite physical links passing traffic and no reported Ethernet errors. Independently, the review flags the potentially unsafe practice “Treat a Level 2-only peer and Level 1-only peer as a guaranteed adjacency”. Which evidence most directly tests the flagged assumption?
- Inspect PDU-size counters and MTU at both interfaces
- Compare adjacent interface circuit types and configured levels
- Inspect IS-IS interface configuration and operational state
- Declare success only because the remote host responds to ICMP
Explanation
Correct Answer
B:Different level-only configurations may have no shared level. Incompatible level settings prevent expected neighbor formation.
Incorrect Answers
A:Larger padded IS-IS hellos can fail despite small ping success.
C:Physical link up is insufficient if routing protocol is not enabled there.
D:ICMP reachability is not IS-IS database synchronization.
Question 169
The NOC sees missing IS-IS neighbors despite physical links passing traffic and no reported Ethernet errors. Independently, the review flags the potentially unsafe practice “Assume an ordinary 64-byte ping verifies padded IS-IS PDU transport”. Which diagnostic check tests this potentially unsafe choice?
- Compare adjacency state and received LSP identifiers
- Run IS-IS only on the management interface and assume core peers discover it
- Inspect PDU-size counters and MTU at both interfaces
- Compare adjacent interface circuit types and configured levels
Explanation
Correct Answer
C:Packet-size differences can impair adjacency. Larger padded IS-IS hellos can fail despite small ping success.
Incorrect Answers
A:A stable adjacency should accompany expected link-state information.
B:Protocol must operate on the intended adjacency interface.
D:Incompatible level settings prevent expected neighbor formation.
Question 170
The NOC sees missing IS-IS neighbors despite physical links passing traffic and no reported Ethernet errors. Independently, the review flags the potentially unsafe practice “Declare success only because the remote host responds to ICMP”. Which validation addresses the risk without assuming a particular cause?
- Assume an ordinary 64-byte ping verifies padded IS-IS PDU transport
- Compare adjacent interface circuit types and configured levels
- Inspect IS-IS interface configuration and operational state
- Compare adjacency state and received LSP identifiers
Explanation
Correct Answer
D:ICMP reachability is not IS-IS database synchronization. A stable adjacency should accompany expected link-state information.
Incorrect Answers
A:Packet-size differences can impair adjacency.
B:Incompatible level settings prevent expected neighbor formation.
C:Physical link up is insufficient if routing protocol is not enabled there.
Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-364) Practice Tests