100% Latest & Updated Juniper JN0-364 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 300
After a customer MAC moves to a new access interface, frames keep reaching the old port and some destinations are temporarily lost. Independently, the review flags the potentially unsafe practice “Treat one successful intra-VLAN ping as proof cross-tenant separation is safe”. Which validation addresses the risk without assuming a particular cause?
- Inspect unknown-unicast counters and bridge-domain membership
- Assume bridge forwarding never uses learned MAC locations
- Check VLAN-specific MAC and flood behavior with both tenants
- Trace MAC move logs and current learned port
Explanation
Correct Answer
C:A single positive test does not assess forbidden paths. A working host-to-host ping does not prove isolation from other VLANs.
Incorrect Answers
A:Unknown unicast behavior differs from known-unicast delivery.
B:Without learning, selective known-unicast forwarding is not possible.
D:Stale MAC bindings can send frames to an old port.
Question 301
A branch switch uplink carries VLANs 120 and 130 but a downstream access port should present only untagged VLAN 120 frames. The objective is to select access-port membership. Which Junos configuration or design action best satisfies the objective?
- Place the ordinary host-facing port in access mode for the approved VLAN
- Allow every possible VLAN tag on every customer-facing trunk
- Assume all frames remain untagged across a configured multi-VLAN trunk
- Declare success because one VLAN works in one direction
Explanation
Correct Answer
A:Access ports typically attach untagged endpoints to one VLAN.
Incorrect Answers
B:Unrestricted membership increases isolation and leakage risk.
C:Multiple VLANs commonly require distinguishable tags.
D:One positive path does not verify the other VLAN or isolation.
Question 302
A branch switch uplink carries VLANs 120 and 130 but a downstream access port should present only untagged VLAN 120 frames. The objective is to preserve trunk VLAN list. Which operational choice should be prioritized in this design?
- Declare success because one VLAN works in one direction
- Restrict tagged uplink membership to explicitly required VLANs
- Configure a normal untagged workstation as an unrestricted all-VLAN trunk
- Assume all frames remain untagged across a configured multi-VLAN trunk
Explanation
Correct Answer
B:Trunk membership limits which tags traverse the uplink.
Incorrect Answers
A:One positive path does not verify the other VLAN or isolation.
C:An accidental trunk may expose unintended VLAN traffic.
D:Multiple VLANs commonly require distinguishable tags.
Question 303
A branch switch uplink carries VLANs 120 and 130 but a downstream access port should present only untagged VLAN 120 frames. The objective is to verify tag treatment. Which routing or switching control best fits the requirement?
- Compare observed tagged and untagged frames with intended port modes
- Allow every possible VLAN tag on every customer-facing trunk
- Declare success because one VLAN works in one direction
- Configure a normal untagged workstation as an unrestricted all-VLAN trunk
Explanation
Correct Answer
A:802.1Q tagging behavior depends on interface and VLAN configuration.
Incorrect Answers
B:Unrestricted membership increases isolation and leakage risk.
C:One positive path does not verify the other VLAN or isolation.
D:An accidental trunk may expose unintended VLAN traffic.
Question 304
A branch switch uplink carries VLANs 120 and 130 but a downstream access port should present only untagged VLAN 120 frames. The objective is to validate bidirectional VLAN reachability. Which verification should be performed before approving the change?
- Check both VLAN 120 and VLAN 130 end-to-end while testing a denied VLAN
- Assume all frames remain untagged across a configured multi-VLAN trunk
- Configure a normal untagged workstation as an unrestricted all-VLAN trunk
- Allow every possible VLAN tag on every customer-facing trunk
Explanation
Correct Answer
A:Correct port configuration must preserve intended and deny unintended traffic.
Incorrect Answers
B:Multiple VLANs commonly require distinguishable tags.
C:An accidental trunk may expose unintended VLAN traffic.
D:Unrestricted membership increases isolation and leakage risk.
Question 305
A branch switch uplink carries VLANs 120 and 130 but a downstream access port should present only untagged VLAN 120 frames. Two objectives apply: (1) select access-port membership; and (2) verify tag treatment. Which TWO controls together satisfy the requirements? Choose TWO.
- Compare observed tagged and untagged frames with intended port modes
- Assume all frames remain untagged across a configured multi-VLAN trunk
- Declare success because one VLAN works in one direction
- Place the ordinary host-facing port in access mode for the approved VLAN
- Configure a normal untagged workstation as an unrestricted all-VLAN trunk
Explanation
Correct Answers
A:802.1Q tagging behavior depends on interface and VLAN configuration.
D:Access ports typically attach untagged endpoints to one VLAN.
Incorrect Answers
B:Multiple VLANs commonly require distinguishable tags.
C:One positive path does not verify the other VLAN or isolation.
E:An accidental trunk may expose unintended VLAN traffic.
Question 306
A branch switch uplink carries VLANs 120 and 130 but a downstream access port should present only untagged VLAN 120 frames. Three objectives apply: (1) select access-port membership; (2) verify tag treatment; and (3) validate bidirectional VLAN reachability. Which THREE controls together satisfy the requirements? Choose THREE.
- Configure a normal untagged workstation as an unrestricted all-VLAN trunk
- Place the ordinary host-facing port in access mode for the approved VLAN
- Check both VLAN 120 and VLAN 130 end-to-end while testing a denied VLAN
- Compare observed tagged and untagged frames with intended port modes
- Declare success because one VLAN works in one direction
- Assume all frames remain untagged across a configured multi-VLAN trunk
Explanation
Correct Answers
B:Access ports typically attach untagged endpoints to one VLAN.
C:Correct port configuration must preserve intended and deny unintended traffic.
D:802.1Q tagging behavior depends on interface and VLAN configuration.
Incorrect Answers
A:An accidental trunk may expose unintended VLAN traffic.
E:One positive path does not verify the other VLAN or isolation.
F:Multiple VLANs commonly require distinguishable tags.
Question 307
A host suddenly receives tagged Ethernet frames after its port was migrated from access mode to a trunk template. Independently, the review flags the potentially unsafe practice “Configure a normal untagged workstation as an unrestricted all-VLAN trunk”. Which inspection best evaluates that practice?
- Inspect packet tags on the uplink and access segment
- Test tagged traffic and per-VLAN interface counters
- Allow every possible VLAN tag on every customer-facing trunk
- Inspect port mode and assigned access VLAN
Explanation
Correct Answer
D:An accidental trunk may expose unintended VLAN traffic. Access ports typically attach untagged endpoints to one VLAN.
Incorrect Answers
A:802.1Q tagging behavior depends on interface and VLAN configuration.
B:Correct port configuration must preserve intended and deny unintended traffic.
C:Unrestricted membership increases isolation and leakage risk.
Question 308
A host suddenly receives tagged Ethernet frames after its port was migrated from access mode to a trunk template. Independently, the review flags the potentially unsafe practice “Allow every possible VLAN tag on every customer-facing trunk”. Which evidence most directly tests the flagged assumption?
- Inspect port mode and assigned access VLAN
- Inspect packet tags on the uplink and access segment
- Declare success because one VLAN works in one direction
- Review allowed VLAN list at both trunk ends
Explanation
Correct Answer
D:Unrestricted membership increases isolation and leakage risk. Trunk membership limits which tags traverse the uplink.
Incorrect Answers
A:Access ports typically attach untagged endpoints to one VLAN.
B:802.1Q tagging behavior depends on interface and VLAN configuration.
C:One positive path does not verify the other VLAN or isolation.
Question 309
A host suddenly receives tagged Ethernet frames after its port was migrated from access mode to a trunk template. Independently, the review flags the potentially unsafe practice “Assume all frames remain untagged across a configured multi-VLAN trunk”. Which diagnostic check tests this potentially unsafe choice?
- Review allowed VLAN list at both trunk ends
- Inspect packet tags on the uplink and access segment
- Configure a normal untagged workstation as an unrestricted all-VLAN trunk
- Test tagged traffic and per-VLAN interface counters
Explanation
Correct Answer
B:Multiple VLANs commonly require distinguishable tags. The relevant control is supported because 802.1Q tagging behavior depends on interface and VLAN configuration.
Incorrect Answers
A:Trunk membership limits which tags traverse the uplink.
C:An accidental trunk may expose unintended VLAN traffic.
D:Correct port configuration must preserve intended and deny unintended traffic.
Question 310
A host suddenly receives tagged Ethernet frames after its port was migrated from access mode to a trunk template. Independently, the review flags the potentially unsafe practice “Declare success because one VLAN works in one direction”. Which validation addresses the risk without assuming a particular cause?
- Inspect port mode and assigned access VLAN
- Review allowed VLAN list at both trunk ends
- Assume all frames remain untagged across a configured multi-VLAN trunk
- Test tagged traffic and per-VLAN interface counters
Explanation
Correct Answer
D:One positive path does not verify the other VLAN or isolation. Correct port configuration must preserve intended and deny unintended traffic.
Incorrect Answers
A:Access ports typically attach untagged endpoints to one VLAN.
B:Trunk membership limits which tags traverse the uplink.
C:Multiple VLANs commonly require distinguishable tags.
Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-364) Practice Tests