100% Latest & Updated Juniper JN0-364 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 320
A customer reports its VLAN frames arrive with the wrong outer service tag after provider-edge migration. Independently, the review flags the potentially unsafe practice “Assume shared C-tag numbers alone prove isolated forwarding”. Which validation addresses the risk without assuming a particular cause?
- Inspect tag rewrite configuration and captured frames
- Place competing customers in one unfiltered bridge domain because their inner VLAN IDs match
- Test each customer's traffic and verify outer-domain confinement
- Inspect ingress and egress inner and outer VLAN tags
Explanation
Correct Answer
C:Equal inner tags can coexist only with correct provider separation. Separating service contexts prevents cross-customer leakage.
Incorrect Answers
A:Encapsulation changes must be symmetric across intended endpoints.
B:Shared inner IDs must not collapse customer isolation.
D:Q-in-Q allows distinct services to share reused customer VLAN IDs.
Question 321
Two access VLANs must communicate through a Junos IRB gateway while hosts in the same VLAN should remain switched at Layer 2. The objective is to associate IRB with bridge domain. Which Junos configuration or design action best satisfies the objective?
- Use the same gateway IP on two unrelated production VLANs without design review
- Declare the IRB working solely because its interface configuration commits
- Bind the appropriate IRB logical interface to the intended VLAN or bridge domain
- Assume bridging alone routes traffic between distinct IP subnets
Explanation
Correct Answer
C:IRB supplies routed service to a bridged segment.
Incorrect Answers
A:Overlapping or duplicate gateways cause ambiguous reachability.
B:Configured IP address is not end-to-end connectivity.
D:Layer 2 forwarding does not by itself perform IP routing.
Question 322
Two access VLANs must communicate through a Junos IRB gateway while hosts in the same VLAN should remain switched at Layer 2. The objective is to set correct gateway subnet. Which operational choice should be prioritized in this design?
- Set a gateway address only on an unrelated management loopback
- Configure the IRB address and subnet matching the attached hosts
- Declare the IRB working solely because its interface configuration commits
- Assume bridging alone routes traffic between distinct IP subnets
Explanation
Correct Answer
B:Hosts need a correctly addressed default gateway in their subnet.
Incorrect Answers
A:An unrelated loopback is not the VLAN's first-hop gateway.
C:Configured IP address is not end-to-end connectivity.
D:Layer 2 forwarding does not by itself perform IP routing.
Question 323
Two access VLANs must communicate through a Junos IRB gateway while hosts in the same VLAN should remain switched at Layer 2. The objective is to allow inter-VLAN routing. Which routing or switching control best fits the requirement?
- Set a gateway address only on an unrelated management loopback
- Verify appropriate routing and security policy for traffic between VLANs
- Use the same gateway IP on two unrelated production VLANs without design review
- Declare the IRB working solely because its interface configuration commits
Explanation
Correct Answer
B:IRB routing crosses the L2 boundary between separate networks.
Incorrect Answers
A:An unrelated loopback is not the VLAN's first-hop gateway.
C:Overlapping or duplicate gateways cause ambiguous reachability.
D:Configured IP address is not end-to-end connectivity.
Question 324
Two access VLANs must communicate through a Junos IRB gateway while hosts in the same VLAN should remain switched at Layer 2. The objective is to validate ARP and forwarding. Which verification should be performed before approving the change?
- Test gateway ARP resolution and traffic through the IRB
- Use the same gateway IP on two unrelated production VLANs without design review
- Assume bridging alone routes traffic between distinct IP subnets
- Set a gateway address only on an unrelated management loopback
Explanation
Correct Answer
A:Successful IP configuration still needs neighbor discovery and forwarding.
Incorrect Answers
B:Overlapping or duplicate gateways cause ambiguous reachability.
C:Layer 2 forwarding does not by itself perform IP routing.
D:An unrelated loopback is not the VLAN's first-hop gateway.
Question 325
Two access VLANs must communicate through a Junos IRB gateway while hosts in the same VLAN should remain switched at Layer 2. Two objectives apply: (1) associate IRB with bridge domain; and (2) allow inter-VLAN routing. Which TWO controls together satisfy the requirements? Choose TWO.
- Assume bridging alone routes traffic between distinct IP subnets
- Declare the IRB working solely because its interface configuration commits
- Set a gateway address only on an unrelated management loopback
- Verify appropriate routing and security policy for traffic between VLANs
- Bind the appropriate IRB logical interface to the intended VLAN or bridge domain
Explanation
Correct Answers
D:IRB routing crosses the L2 boundary between separate networks.
E:IRB supplies routed service to a bridged segment.
Incorrect Answers
A:Layer 2 forwarding does not by itself perform IP routing.
B:Configured IP address is not end-to-end connectivity.
C:An unrelated loopback is not the VLAN's first-hop gateway.
Question 326
Two access VLANs must communicate through a Junos IRB gateway while hosts in the same VLAN should remain switched at Layer 2. Three objectives apply: (1) associate IRB with bridge domain; (2) set correct gateway subnet; and (3) validate ARP and forwarding. Which THREE controls together satisfy the requirements? Choose THREE.
- Assume bridging alone routes traffic between distinct IP subnets
- Test gateway ARP resolution and traffic through the IRB
- Declare the IRB working solely because its interface configuration commits
- Bind the appropriate IRB logical interface to the intended VLAN or bridge domain
- Set a gateway address only on an unrelated management loopback
- Configure the IRB address and subnet matching the attached hosts
Explanation
Correct Answers
B:Successful IP configuration still needs neighbor discovery and forwarding.
D:IRB supplies routed service to a bridged segment.
F:Hosts need a correctly addressed default gateway in their subnet.
Incorrect Answers
A:Layer 2 forwarding does not by itself perform IP routing.
C:Configured IP address is not end-to-end connectivity.
E:An unrelated loopback is not the VLAN's first-hop gateway.
Question 327
Hosts can reach peers inside one bridge domain but cannot reach the configured gateway IP after an IRB migration. Independently, the review flags the potentially unsafe practice “Set a gateway address only on an unrelated management loopback”. Which inspection best evaluates that practice?
- Use the same gateway IP on two unrelated production VLANs without design review
- Compare ARP entries, IRB interface state and data-plane counters
- Inspect bridge-domain routing-interface association
- Inspect route table and relevant filtering for inter-VLAN traffic
Explanation
Correct Answer
C:An unrelated loopback is not the VLAN's first-hop gateway. IRB supplies routed service to a bridged segment.
Incorrect Answers
A:Overlapping or duplicate gateways cause ambiguous reachability.
B:Successful IP configuration still needs neighbor discovery and forwarding.
D:IRB routing crosses the L2 boundary between separate networks.
Question 328
Hosts can reach peers inside one bridge domain but cannot reach the configured gateway IP after an IRB migration. Independently, the review flags the potentially unsafe practice “Use the same gateway IP on two unrelated production VLANs without design review”. Which evidence most directly tests the flagged assumption?
- Check IRB family inet address and host default-gateway settings
- Compare ARP entries, IRB interface state and data-plane counters
- Set a gateway address only on an unrelated management loopback
- Inspect route table and relevant filtering for inter-VLAN traffic
Explanation
Correct Answer
A:Overlapping or duplicate gateways cause ambiguous reachability. Hosts need a correctly addressed default gateway in their subnet.
Incorrect Answers
B:Successful IP configuration still needs neighbor discovery and forwarding.
C:An unrelated loopback is not the VLAN's first-hop gateway.
D:IRB routing crosses the L2 boundary between separate networks.
Question 329
Hosts can reach peers inside one bridge domain but cannot reach the configured gateway IP after an IRB migration. Independently, the review flags the potentially unsafe practice “Assume bridging alone routes traffic between distinct IP subnets”. Which diagnostic check tests this potentially unsafe choice?
- Inspect route table and relevant filtering for inter-VLAN traffic
- Check IRB family inet address and host default-gateway settings
- Compare ARP entries, IRB interface state and data-plane counters
- Set a gateway address only on an unrelated management loopback
Explanation
Correct Answer
A:Layer 2 forwarding does not by itself perform IP routing. IRB routing crosses the L2 boundary between separate networks.
Incorrect Answers
B:Hosts need a correctly addressed default gateway in their subnet.
C:Successful IP configuration still needs neighbor discovery and forwarding.
D:An unrelated loopback is not the VLAN's first-hop gateway.
Question 330
Hosts can reach peers inside one bridge domain but cannot reach the configured gateway IP after an IRB migration. Independently, the review flags the potentially unsafe practice “Declare the IRB working solely because its interface configuration commits”. Which validation addresses the risk without assuming a particular cause?
- Compare ARP entries, IRB interface state and data-plane counters
- Check IRB family inet address and host default-gateway settings
- Set a gateway address only on an unrelated management loopback
- Inspect route table and relevant filtering for inter-VLAN traffic
Explanation
Correct Answer
A:Configured IP address is not end-to-end connectivity. Successful IP configuration still needs neighbor discovery and forwarding.
Incorrect Answers
B:Hosts need a correctly addressed default gateway in their subnet.
C:An unrelated loopback is not the VLAN's first-hop gateway.
D:IRB routing crosses the L2 boundary between separate networks.
Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-364) Practice Tests