Juniper JN0-364 Exam Dumps, Practice Test Questions

100% Latest & Updated Juniper JN0-364 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!

Juniper JN0-364  Premium File
$54.99
$49.99

JN0-364 Premium File

  • Premium File: 69 Questions & Answers. Last update: Nov 9, 2026
  • Latest Questions
  • 100% Accurate Answers
  • Fast Exam Updates

JN0-364 Premium File

Juniper JN0-364  Premium File
  • Premium File: 69 Questions & Answers. Last update: Nov 9, 2026
  • Latest Questions
  • 100% Accurate Answers
  • Fast Exam Updates
$54.99
$49.99

Juniper JN0-364 Practice Test 48

Question 470

LDP sessions remain Up but packets bypass the engineered LSP because the LDP-over-RSVP resolution has not been applied as intended. Independently, the review flags the potentially unsafe practice “Declare success because both protocols separately show neighbors Up”. Which validation addresses the risk without assuming a particular cause?

  1. Inspect RSVP LSP state and actual endpoints
  2. Inspect ingress label stack and transit swap or pop behavior
  3. Expect LDP always to use RSVP paths even if tunneling is not enabled
  4. Compare actual LDP-carried path with intended RSVP LSP

Explanation

Correct Answer

D:

Independent protocol sessions do not prove combined forwarding. A configuration may appear valid while forwarding chooses a different route.

Incorrect Answers

A:

LDP traffic cannot rely on a failed underlying RSVP transport LSP.

B:

Tunneling commonly pushes transport label outside service label.

C:

LDP can follow ordinary IGP paths absent the intended tunneling feature.

Question 471

An edge PE receives 2001:db8:120::/48 traffic over a customer handoff and points a static route at a link-local next hop. The objective is to scope link-local next hop. Which Junos configuration or design action best satisfies the objective?

  1. Declare success solely because the interface has an inet6 address
  2. Specify the correct outgoing interface when resolving an IPv6 link-local next hop
  3. Advertise ::/0 as a replacement for an incorrectly masked customer /48
  4. Assume IPv4 ARP entries establish every IPv6 neighbor mapping

Explanation

Correct Answer

B:

Link-local addresses are only meaningful on a particular local link.

Incorrect Answers

A:

Address presence does not guarantee remote reachability.

C:

A default route is broader than a customer prefix.

D:

IPv6 uses Neighbor Discovery rather than IPv4 ARP.

Question 472

An edge PE receives 2001:db8:120::/48 traffic over a customer handoff and points a static route at a link-local next hop. The objective is to verify IPv6 NDP. Which operational choice should be prioritized in this design?

  1. Advertise ::/0 as a replacement for an incorrectly masked customer /48
  2. Treat fe80::1 as globally unambiguous across all interfaces
  3. Declare success solely because the interface has an inet6 address
  4. Check neighbor discovery for the link-local gateway on the intended link

Explanation

Correct Answer

D:

IPv6 forwarding needs link-layer reachability to local next hops.

Incorrect Answers

A:

A default route is broader than a customer prefix.

B:

A link-local identifier can exist on multiple links.

C:

Address presence does not guarantee remote reachability.

Question 473

An edge PE receives 2001:db8:120::/48 traffic over a customer handoff and points a static route at a link-local next hop. The objective is to check longest-prefix routing. Which routing or switching control best fits the requirement?

  1. Confirm the static IPv6 prefix covers only authorized downstream routes
  2. Assume IPv4 ARP entries establish every IPv6 neighbor mapping
  3. Declare success solely because the interface has an inet6 address
  4. Treat fe80::1 as globally unambiguous across all interfaces

Explanation

Correct Answer

A:

Incorrect prefix length can redirect unintended IPv6 destinations.

Incorrect Answers

B:

IPv6 uses Neighbor Discovery rather than IPv4 ARP.

C:

Address presence does not guarantee remote reachability.

D:

A link-local identifier can exist on multiple links.

Question 474

An edge PE receives 2001:db8:120::/48 traffic over a customer handoff and points a static route at a link-local next hop. The objective is to validate data-plane delivery. Which verification should be performed before approving the change?

  1. Treat fe80::1 as globally unambiguous across all interfaces
  2. Assume IPv4 ARP entries establish every IPv6 neighbor mapping
  3. Advertise ::/0 as a replacement for an incorrectly masked customer /48
  4. Use source-aware IPv6 probes and route lookup after correcting neighbor resolution

Explanation

Correct Answer

D:

A configured static route alone does not prove end-to-end IPv6 traffic.

Incorrect Answers

A:

A link-local identifier can exist on multiple links.

B:

IPv6 uses Neighbor Discovery rather than IPv4 ARP.

C:

A default route is broader than a customer prefix.

Question 475

An edge PE receives 2001:db8:120::/48 traffic over a customer handoff and points a static route at a link-local next hop. Two objectives apply: (1) verify IPv6 NDP; and (2) validate data-plane delivery. Which TWO controls together satisfy the requirements? Choose TWO.

  1. Check neighbor discovery for the link-local gateway on the intended link
  2. Declare success solely because the interface has an inet6 address
  3. Use source-aware IPv6 probes and route lookup after correcting neighbor resolution
  4. Advertise ::/0 as a replacement for an incorrectly masked customer /48
  5. Assume IPv4 ARP entries establish every IPv6 neighbor mapping

Explanation

Correct Answers

A:

IPv6 forwarding needs link-layer reachability to local next hops.

C:

A configured static route alone does not prove end-to-end IPv6 traffic.

Incorrect Answers

B:

Address presence does not guarantee remote reachability.

D:

A default route is broader than a customer prefix.

E:

IPv6 uses Neighbor Discovery rather than IPv4 ARP.

Question 476

An edge PE receives 2001:db8:120::/48 traffic over a customer handoff and points a static route at a link-local next hop. Three objectives apply: (1) scope link-local next hop; (2) verify IPv6 NDP; and (3) validate data-plane delivery. Which THREE controls together satisfy the requirements? Choose THREE.

  1. Declare success solely because the interface has an inet6 address
  2. Use source-aware IPv6 probes and route lookup after correcting neighbor resolution
  3. Check neighbor discovery for the link-local gateway on the intended link
  4. Assume IPv4 ARP entries establish every IPv6 neighbor mapping
  5. Advertise ::/0 as a replacement for an incorrectly masked customer /48
  6. Specify the correct outgoing interface when resolving an IPv6 link-local next hop

Explanation

Correct Answers

B:

A configured static route alone does not prove end-to-end IPv6 traffic.

C:

IPv6 forwarding needs link-layer reachability to local next hops.

F:

Link-local addresses are only meaningful on a particular local link.

Incorrect Answers

A:

Address presence does not guarantee remote reachability.

D:

IPv6 uses Neighbor Discovery rather than IPv4 ARP.

E:

A default route is broader than a customer prefix.

Question 477

The route exists in configuration but forwarding fails because the intended outgoing interface is not associated with the link-local next hop. Independently, the review flags the potentially unsafe practice “Treat fe80::1 as globally unambiguous across all interfaces”. Which inspection best evaluates that practice?

  1. Inspect IPv6 neighbor table for the selected interface
  2. Declare success solely because the interface has an inet6 address
  3. Inspect the active IPv6 route for a representative /48 address
  4. Inspect static route next-hop address and interface binding

Explanation

Correct Answer

D:

A link-local identifier can exist on multiple links. Link-local addresses are only meaningful on a particular local link.

Incorrect Answers

A:

IPv6 forwarding needs link-layer reachability to local next hops.

B:

Address presence does not guarantee remote reachability.

C:

Incorrect prefix length can redirect unintended IPv6 destinations.

Question 478

The route exists in configuration but forwarding fails because the intended outgoing interface is not associated with the link-local next hop. Independently, the review flags the potentially unsafe practice “Assume IPv4 ARP entries establish every IPv6 neighbor mapping”. Which evidence most directly tests the flagged assumption?

  1. Advertise ::/0 as a replacement for an incorrectly masked customer /48
  2. Check forwarding-table next hop and IPv6 packet counters
  3. Inspect IPv6 neighbor table for the selected interface
  4. Inspect static route next-hop address and interface binding

Explanation

Correct Answer

C:

IPv6 uses Neighbor Discovery rather than IPv4 ARP. IPv6 forwarding needs link-layer reachability to local next hops.

Incorrect Answers

A:

A default route is broader than a customer prefix.

B:

A configured static route alone does not prove end-to-end IPv6 traffic.

D:

Link-local addresses are only meaningful on a particular local link.

Question 479

The route exists in configuration but forwarding fails because the intended outgoing interface is not associated with the link-local next hop. Independently, the review flags the potentially unsafe practice “Advertise ::/0 as a replacement for an incorrectly masked customer /48”. Which diagnostic check tests this potentially unsafe choice?

  1. Check forwarding-table next hop and IPv6 packet counters
  2. Inspect static route next-hop address and interface binding
  3. Inspect the active IPv6 route for a representative /48 address
  4. Assume IPv4 ARP entries establish every IPv6 neighbor mapping

Explanation

Correct Answer

C:

A default route is broader than a customer prefix. Incorrect prefix length can redirect unintended IPv6 destinations.

Incorrect Answers

A:

A configured static route alone does not prove end-to-end IPv6 traffic.

B:

Link-local addresses are only meaningful on a particular local link.

D:

IPv6 uses Neighbor Discovery rather than IPv4 ARP.

Question 480

The route exists in configuration but forwarding fails because the intended outgoing interface is not associated with the link-local next hop. Independently, the review flags the potentially unsafe practice “Declare success solely because the interface has an inet6 address”. Which validation addresses the risk without assuming a particular cause?

  1. Treat fe80::1 as globally unambiguous across all interfaces
  2. Inspect IPv6 neighbor table for the selected interface
  3. Check forwarding-table next hop and IPv6 packet counters
  4. Inspect the active IPv6 route for a representative /48 address

Explanation

Correct Answer

C:

Address presence does not guarantee remote reachability. A configured static route alone does not prove end-to-end IPv6 traffic.

Incorrect Answers

A:

A link-local identifier can exist on multiple links.

B:

IPv6 forwarding needs link-layer reachability to local next hops.

D:

Incorrect prefix length can redirect unintended IPv6 destinations.

Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-364) Practice Tests

UP

SPECIAL OFFER: GET 10% OFF

This is ONE TIME OFFER

ExamSnap Discount Offer
Enter Your Email Address to Receive Your 10% Off Discount Code

A confirmation link will be sent to this email address to verify your login. *We value your privacy. We will not rent or sell your email address.

Download Free Demo of VCE Exam Simulator

Experience Avanset VCE Exam Simulator for yourself.

Simply submit your e-mail address below to get started with our interactive software demo of your free trial.

Free Demo Limits: In the demo version you will be able to access only first 5 questions from exam.