Juniper JN0-364 Exam Dumps, Practice Test Questions

100% Latest & Updated Juniper JN0-364 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!

Juniper JN0-364  Premium File
$54.99
$49.99

JN0-364 Premium File

  • Premium File: 69 Questions & Answers. Last update: Nov 9, 2026
  • Latest Questions
  • 100% Accurate Answers
  • Fast Exam Updates

JN0-364 Premium File

Juniper JN0-364  Premium File
  • Premium File: 69 Questions & Answers. Last update: Nov 9, 2026
  • Latest Questions
  • 100% Accurate Answers
  • Fast Exam Updates
$54.99
$49.99

Juniper JN0-364 Practice Test 52

Question 510

The IPv4 peer exchanges prefixes while the IPv6 address-family route remains absent due to family capability or policy configuration. Independently, the review flags the potentially unsafe practice “Declare IPv6 BGP operational solely because IPv4 prefix counters rise”. Which validation addresses the risk without assuming a particular cause?

  1. Assume an IPv4-only BGP session always exchanges IPv6 reachability
  2. Inspect inet6 import and export policy matches
  3. Inspect IPv6 advertised routes and local inet6.0 state
  4. Inspect received MP_REACH next-hop and inet6 resolution

Explanation

Correct Answer

C:

IPv4 route counts do not validate IPv6 family exchange. Receipt, acceptance and route selection are separate steps.

Incorrect Answers

A:

Multiprotocol capability or family configuration controls IPv6 route exchange.

B:

An enabled family may exchange zero accepted routes under policy.

D:

IPv6 BGP next-hop resolution can fail independently of IPv4 peering.

Question 511

Two islands have IPv6-only customer subnets but the intermediate provider transport is IPv4 and they plan a supported IPv6-over-IPv4 tunnel. The objective is to verify IPv4 underlay reachability. Which Junos configuration or design action best satisfies the objective?

  1. Use the same remote destination address for every unrelated tunnel by mistake
  2. Assume IPv6-in-IPv4 uses no extra header bytes
  3. Ensure the source and destination IPv4 tunnel endpoints have stable underlay routes
  4. Point the remote IPv6 prefix at a non-tunnel management link

Explanation

Correct Answer

C:

Encapsulated IPv6 traffic requires functional IPv4 transport.

Incorrect Answers

A:

Wrong endpoints misdirect encapsulated traffic.

B:

Encapsulation may cause size-dependent loss.

D:

The selected next hop must lead toward the remote IPv6 island.

Question 512

Two islands have IPv6-only customer subnets but the intermediate provider transport is IPv4 and they plan a supported IPv6-over-IPv4 tunnel. The objective is to configure correct tunnel endpoints. Which operational choice should be prioritized in this design?

  1. Match encapsulation type, source and destination addresses on both participating devices
  2. Assume IPv6-in-IPv4 uses no extra header bytes
  3. Point the remote IPv6 prefix at a non-tunnel management link
  4. Assume an IPv6 tunnel can work without reachability to its IPv4 outer destination

Explanation

Correct Answer

A:

Endpoint agreement determines where tunneled packets are delivered.

Incorrect Answers

B:

Encapsulation may cause size-dependent loss.

C:

The selected next hop must lead toward the remote IPv6 island.

D:

Missing underlay routing prevents encapsulated delivery.

Question 513

Two islands have IPv6-only customer subnets but the intermediate provider transport is IPv4 and they plan a supported IPv6-over-IPv4 tunnel. The objective is to route IPv6 over the tunnel. Which routing or switching control best fits the requirement?

  1. Use the same remote destination address for every unrelated tunnel by mistake
  2. Install appropriate IPv6 routes pointing to the tunnel logical interface
  3. Assume IPv6-in-IPv4 uses no extra header bytes
  4. Assume an IPv6 tunnel can work without reachability to its IPv4 outer destination

Explanation

Correct Answer

B:

Successful tunnel formation does not create remote IPv6 routes automatically.

Incorrect Answers

A:

Wrong endpoints misdirect encapsulated traffic.

C:

Encapsulation may cause size-dependent loss.

D:

Missing underlay routing prevents encapsulated delivery.

Question 514

Two islands have IPv6-only customer subnets but the intermediate provider transport is IPv4 and they plan a supported IPv6-over-IPv4 tunnel. The objective is to allow encapsulation overhead. Which verification should be performed before approving the change?

  1. Check MTU and packet delivery for IPv6 payloads within the IPv4 tunnel
  2. Point the remote IPv6 prefix at a non-tunnel management link
  3. Use the same remote destination address for every unrelated tunnel by mistake
  4. Assume an IPv6 tunnel can work without reachability to its IPv4 outer destination

Explanation

Correct Answer

A:

Outer IPv4 encapsulation increases transmitted size.

Incorrect Answers

B:

The selected next hop must lead toward the remote IPv6 island.

C:

Wrong endpoints misdirect encapsulated traffic.

D:

Missing underlay routing prevents encapsulated delivery.

Question 515

Two islands have IPv6-only customer subnets but the intermediate provider transport is IPv4 and they plan a supported IPv6-over-IPv4 tunnel. Two objectives apply: (1) configure correct tunnel endpoints; and (2) allow encapsulation overhead. Which TWO controls together satisfy the requirements? Choose TWO.

  1. Check MTU and packet delivery for IPv6 payloads within the IPv4 tunnel
  2. Match encapsulation type, source and destination addresses on both participating devices
  3. Use the same remote destination address for every unrelated tunnel by mistake
  4. Assume an IPv6 tunnel can work without reachability to its IPv4 outer destination
  5. Point the remote IPv6 prefix at a non-tunnel management link

Explanation

Correct Answers

A:

Outer IPv4 encapsulation increases transmitted size.

B:

Endpoint agreement determines where tunneled packets are delivered.

Incorrect Answers

C:

Wrong endpoints misdirect encapsulated traffic.

D:

Missing underlay routing prevents encapsulated delivery.

E:

The selected next hop must lead toward the remote IPv6 island.

Question 516

Two islands have IPv6-only customer subnets but the intermediate provider transport is IPv4 and they plan a supported IPv6-over-IPv4 tunnel. Three objectives apply: (1) verify IPv4 underlay reachability; (2) route IPv6 over the tunnel; and (3) allow encapsulation overhead. Which THREE controls together satisfy the requirements? Choose THREE.

  1. Ensure the source and destination IPv4 tunnel endpoints have stable underlay routes
  2. Install appropriate IPv6 routes pointing to the tunnel logical interface
  3. Point the remote IPv6 prefix at a non-tunnel management link
  4. Assume an IPv6 tunnel can work without reachability to its IPv4 outer destination
  5. Assume IPv6-in-IPv4 uses no extra header bytes
  6. Check MTU and packet delivery for IPv6 payloads within the IPv4 tunnel

Explanation

Correct Answers

A:

Encapsulated IPv6 traffic requires functional IPv4 transport.

B:

Successful tunnel formation does not create remote IPv6 routes automatically.

F:

Outer IPv4 encapsulation increases transmitted size.

Incorrect Answers

C:

The selected next hop must lead toward the remote IPv6 island.

D:

Missing underlay routing prevents encapsulated delivery.

E:

Encapsulation may cause size-dependent loss.

Question 517

IPv4 transport endpoints ping successfully, yet the far-end IPv6 LAN is unreachable after a tunnel interface change. Independently, the review flags the potentially unsafe practice “Assume an IPv6 tunnel can work without reachability to its IPv4 outer destination”. Which inspection best evaluates that practice?

  1. Use the same remote destination address for every unrelated tunnel by mistake
  2. Probe packet-size limits and tunnel interface counters
  3. Inspect outer IPv4 route and source address selection
  4. Inspect inet6 route to remote prefix and tunnel interface

Explanation

Correct Answer

C:

Missing underlay routing prevents encapsulated delivery. Encapsulated IPv6 traffic requires functional IPv4 transport.

Incorrect Answers

A:

Wrong endpoints misdirect encapsulated traffic.

B:

Outer IPv4 encapsulation increases transmitted size.

D:

Successful tunnel formation does not create remote IPv6 routes automatically.

Question 518

IPv4 transport endpoints ping successfully, yet the far-end IPv6 LAN is unreachable after a tunnel interface change. Independently, the review flags the potentially unsafe practice “Use the same remote destination address for every unrelated tunnel by mistake”. Which evidence most directly tests the flagged assumption?

  1. Assume IPv6-in-IPv4 uses no extra header bytes
  2. Compare tunnel source and destination on each router
  3. Inspect outer IPv4 route and source address selection
  4. Inspect inet6 route to remote prefix and tunnel interface

Explanation

Correct Answer

B:

Wrong endpoints misdirect encapsulated traffic. Endpoint agreement determines where tunneled packets are delivered.

Incorrect Answers

A:

Encapsulation may cause size-dependent loss.

C:

Encapsulated IPv6 traffic requires functional IPv4 transport.

D:

Successful tunnel formation does not create remote IPv6 routes automatically.

Question 519

IPv4 transport endpoints ping successfully, yet the far-end IPv6 LAN is unreachable after a tunnel interface change. Independently, the review flags the potentially unsafe practice “Point the remote IPv6 prefix at a non-tunnel management link”. Which diagnostic check tests this potentially unsafe choice?

  1. Probe packet-size limits and tunnel interface counters
  2. Use the same remote destination address for every unrelated tunnel by mistake
  3. Inspect outer IPv4 route and source address selection
  4. Inspect inet6 route to remote prefix and tunnel interface

Explanation

Correct Answer

D:

The selected next hop must lead toward the remote IPv6 island. Successful tunnel formation does not create remote IPv6 routes automatically.

Incorrect Answers

A:

Outer IPv4 encapsulation increases transmitted size.

B:

Wrong endpoints misdirect encapsulated traffic.

C:

Encapsulated IPv6 traffic requires functional IPv4 transport.

Question 520

IPv4 transport endpoints ping successfully, yet the far-end IPv6 LAN is unreachable after a tunnel interface change. Independently, the review flags the potentially unsafe practice “Assume IPv6-in-IPv4 uses no extra header bytes”. Which validation addresses the risk without assuming a particular cause?

  1. Use the same remote destination address for every unrelated tunnel by mistake
  2. Inspect inet6 route to remote prefix and tunnel interface
  3. Probe packet-size limits and tunnel interface counters
  4. Inspect outer IPv4 route and source address selection

Explanation

Correct Answer

C:

Encapsulation may cause size-dependent loss. Outer IPv4 encapsulation increases transmitted size.

Incorrect Answers

A:

Wrong endpoints misdirect encapsulated traffic.

B:

Successful tunnel formation does not create remote IPv6 routes automatically.

D:

Encapsulated IPv6 traffic requires functional IPv4 transport.

Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-364) Practice Tests

UP

SPECIAL OFFER: GET 10% OFF

This is ONE TIME OFFER

ExamSnap Discount Offer
Enter Your Email Address to Receive Your 10% Off Discount Code

A confirmation link will be sent to this email address to verify your login. *We value your privacy. We will not rent or sell your email address.

Download Free Demo of VCE Exam Simulator

Experience Avanset VCE Exam Simulator for yourself.

Simply submit your e-mail address below to get started with our interactive software demo of your free trial.

Free Demo Limits: In the demo version you will be able to access only first 5 questions from exam.