Juniper JN0-364 Exam Dumps, Practice Test Questions

100% Latest & Updated Juniper JN0-364 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!

Juniper JN0-364  Premium File
$54.99
$49.99

JN0-364 Premium File

  • Premium File: 69 Questions & Answers. Last update: Nov 9, 2026
  • Latest Questions
  • 100% Accurate Answers
  • Fast Exam Updates

JN0-364 Premium File

Juniper JN0-364  Premium File
  • Premium File: 69 Questions & Answers. Last update: Nov 9, 2026
  • Latest Questions
  • 100% Accurate Answers
  • Fast Exam Updates
$54.99
$49.99

Juniper JN0-364 Practice Test 37

Question 360

After adding a switch, traffic briefly reconverges through an unexpected root because bridge priorities were left unreviewed. Independently, the review flags the potentially unsafe practice “Declare resilience proven by the configured bridge priority”. Which validation addresses the risk without assuming a particular cause?

  1. Review root transition history and traffic during test
  2. Inspect root-port role and root path cost
  3. Force every redundant port into forwarding to maximize capacity
  4. Inspect bridge priorities and elected root identifier

Explanation

Correct Answer

A:

A priority value does not show convergence outcome. A documented root choice needs operational failover validation.

Incorrect Answers

B:

Root-port selection depends on path and bridge tie breakers.

C:

Uncontrolled redundant forwarding can cause broadcast storms.

D:

Root election is based on bridge identifier criteria.

Question 361

A switched ring uses RSTP, but an engineer interprets an Alternate port in discarding state as an unusable failed link. The objective is to interpret alternate role. Which Junos configuration or design action best satisfies the objective?

  1. Recognize an alternate port as a loop-free standby path under RSTP
  2. Treat a simple link-up light as proof rapid negotiation succeeded
  3. Assume RSTP always recovers instantaneously on every topology
  4. Enable edge mode on every inter-switch link without assessment

Explanation

Correct Answer

A:

An alternate port may intentionally discard traffic until needed.

Incorrect Answers

B:

Physical connectivity does not prove RSTP agreement.

C:

Convergence depends on peer behavior and topology.

D:

Bridge-facing edge misuse can undermine topology safety.

Question 362

A switched ring uses RSTP, but an engineer interprets an Alternate port in discarding state as an unusable failed link. The objective is to use edge port correctly. Which operational choice should be prioritized in this design?

  1. Treat a simple link-up light as proof rapid negotiation succeeded
  2. Apply edge behavior only to ports attached to intended endpoint devices
  3. Force every alternate port to forward continuously
  4. Assume RSTP always recovers instantaneously on every topology

Explanation

Correct Answer

B:

An edge port can transition rapidly without a bridge neighbor.

Incorrect Answers

A:

Physical connectivity does not prove RSTP agreement.

C:

Concurrent redundant forwarding can create loops.

D:

Convergence depends on peer behavior and topology.

Question 363

A switched ring uses RSTP, but an engineer interprets an Alternate port in discarding state as an unusable failed link. The objective is to check proposal-agreement exchange. Which routing or switching control best fits the requirement?

  1. Inspect rapid transition signaling and neighbor compatibility where applicable
  2. Assume RSTP always recovers instantaneously on every topology
  3. Force every alternate port to forward continuously
  4. Enable edge mode on every inter-switch link without assessment

Explanation

Correct Answer

A:

RSTP uses proposal and agreement to accelerate suitable port transitions.

Incorrect Answers

B:

Convergence depends on peer behavior and topology.

C:

Concurrent redundant forwarding can create loops.

D:

Bridge-facing edge misuse can undermine topology safety.

Question 364

A switched ring uses RSTP, but an engineer interprets an Alternate port in discarding state as an unusable failed link. The objective is to measure recovery. Which verification should be performed before approving the change?

  1. Treat a simple link-up light as proof rapid negotiation succeeded
  2. Enable edge mode on every inter-switch link without assessment
  3. Compare failure-to-forwarding intervals with the operational expectation
  4. Force every alternate port to forward continuously

Explanation

Correct Answer

C:

Convergence validation must use live state and traffic results.

Incorrect Answers

A:

Physical connectivity does not prove RSTP agreement.

B:

Bridge-facing edge misuse can undermine topology safety.

D:

Concurrent redundant forwarding can create loops.

Question 365

A switched ring uses RSTP, but an engineer interprets an Alternate port in discarding state as an unusable failed link. Two objectives apply: (1) interpret alternate role; and (2) check proposal-agreement exchange. Which TWO controls together satisfy the requirements? Choose TWO.

  1. Enable edge mode on every inter-switch link without assessment
  2. Treat a simple link-up light as proof rapid negotiation succeeded
  3. Inspect rapid transition signaling and neighbor compatibility where applicable
  4. Force every alternate port to forward continuously
  5. Recognize an alternate port as a loop-free standby path under RSTP

Explanation

Correct Answers

C:

RSTP uses proposal and agreement to accelerate suitable port transitions.

E:

An alternate port may intentionally discard traffic until needed.

Incorrect Answers

A:

Bridge-facing edge misuse can undermine topology safety.

B:

Physical connectivity does not prove RSTP agreement.

D:

Concurrent redundant forwarding can create loops.

Question 366

A switched ring uses RSTP, but an engineer interprets an Alternate port in discarding state as an unusable failed link. Three objectives apply: (1) interpret alternate role; (2) check proposal-agreement exchange; and (3) measure recovery. Which THREE controls together satisfy the requirements? Choose THREE.

  1. Enable edge mode on every inter-switch link without assessment
  2. Recognize an alternate port as a loop-free standby path under RSTP
  3. Treat a simple link-up light as proof rapid negotiation succeeded
  4. Inspect rapid transition signaling and neighbor compatibility where applicable
  5. Compare failure-to-forwarding intervals with the operational expectation
  6. Force every alternate port to forward continuously

Explanation

Correct Answers

B:

An alternate port may intentionally discard traffic until needed.

D:

RSTP uses proposal and agreement to accelerate suitable port transitions.

E:

Convergence validation must use live state and traffic results.

Incorrect Answers

A:

Bridge-facing edge misuse can undermine topology safety.

C:

Physical connectivity does not prove RSTP agreement.

F:

Concurrent redundant forwarding can create loops.

Question 367

After a link failure, a standby segment takes longer than expected to transition and packet loss persists until topology stabilizes. Independently, the review flags the potentially unsafe practice “Force every alternate port to forward continuously”. Which inspection best evaluates that practice?

  1. Inspect RSTP port role and state together
  2. Inspect RSTP state transitions and BPDU exchange
  3. Verify attached device type and edge-port configuration
  4. Assume RSTP always recovers instantaneously on every topology

Explanation

Correct Answer

A:

Concurrent redundant forwarding can create loops. An alternate port may intentionally discard traffic until needed.

Incorrect Answers

B:

RSTP uses proposal and agreement to accelerate suitable port transitions.

C:

An edge port can transition rapidly without a bridge neighbor.

D:

Convergence depends on peer behavior and topology.

Question 368

After a link failure, a standby segment takes longer than expected to transition and packet loss persists until topology stabilizes. Independently, the review flags the potentially unsafe practice “Enable edge mode on every inter-switch link without assessment”. Which evidence most directly tests the flagged assumption?

  1. Test link failure and recorded port-state recovery
  2. Treat a simple link-up light as proof rapid negotiation succeeded
  3. Inspect RSTP port role and state together
  4. Verify attached device type and edge-port configuration

Explanation

Correct Answer

D:

Bridge-facing edge misuse can undermine topology safety. An edge port can transition rapidly without a bridge neighbor.

Incorrect Answers

A:

Convergence validation must use live state and traffic results.

B:

Physical connectivity does not prove RSTP agreement.

C:

An alternate port may intentionally discard traffic until needed.

Question 369

After a link failure, a standby segment takes longer than expected to transition and packet loss persists until topology stabilizes. Independently, the review flags the potentially unsafe practice “Treat a simple link-up light as proof rapid negotiation succeeded”. Which diagnostic check tests this potentially unsafe choice?

  1. Verify attached device type and edge-port configuration
  2. Force every alternate port to forward continuously
  3. Inspect RSTP state transitions and BPDU exchange
  4. Test link failure and recorded port-state recovery

Explanation

Correct Answer

C:

Physical connectivity does not prove RSTP agreement. RSTP uses proposal and agreement to accelerate suitable port transitions.

Incorrect Answers

A:

An edge port can transition rapidly without a bridge neighbor.

B:

Concurrent redundant forwarding can create loops.

D:

Convergence validation must use live state and traffic results.

Question 370

After a link failure, a standby segment takes longer than expected to transition and packet loss persists until topology stabilizes. Independently, the review flags the potentially unsafe practice “Assume RSTP always recovers instantaneously on every topology”. Which validation addresses the risk without assuming a particular cause?

  1. Verify attached device type and edge-port configuration
  2. Inspect RSTP state transitions and BPDU exchange
  3. Test link failure and recorded port-state recovery
  4. Force every alternate port to forward continuously

Explanation

Correct Answer

C:

Convergence depends on peer behavior and topology. Convergence validation must use live state and traffic results.

Incorrect Answers

A:

An edge port can transition rapidly without a bridge neighbor.

B:

RSTP uses proposal and agreement to accelerate suitable port transitions.

D:

Concurrent redundant forwarding can create loops.

Service Provider Routing and Switching, Specialist (JNCIS-SP) (JN0-364) Practice Tests

UP

SPECIAL OFFER: GET 10% OFF

This is ONE TIME OFFER

ExamSnap Discount Offer
Enter Your Email Address to Receive Your 10% Off Discount Code

A confirmation link will be sent to this email address to verify your login. *We value your privacy. We will not rent or sell your email address.

Download Free Demo of VCE Exam Simulator

Experience Avanset VCE Exam Simulator for yourself.

Simply submit your e-mail address below to get started with our interactive software demo of your free trial.

Free Demo Limits: In the demo version you will be able to access only first 5 questions from exam.