100% Latest & Updated Microsoft AZ-801 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 390
A postdisaster review reports ASR replication green but does not retain actual failover application success evidence. Which administrative change most directly resolves the documented failure?
- Select a recovery point class that meets the application's consistency and RPO requirements.
- Initiate the approved unplanned ASR failover using a suitable available recovery point.
- Use the application recovery plan to recover all required dependent tiers together.
- Record end-to-end RTO/RPO, recovery-point selection and application validation for the drill.
Explanation
Correct Answer
D:Replication health measures data movement, not complete recovered service usability. A suitable corrective action is to record end-to-end RTO/RPO, recovery-point selection and application validation for the drill.
Incorrect Answers
A:Application-consistent checkpoints and crash-consistent snapshots offer different guarantees. However, replication health measures data movement, not complete recovered service usability.
B:During a hard outage, the primary source cannot supply fresh changes; recovery must use replicated points. Here, replication health measures data movement, not complete recovered service usability.
C:Partial VM recovery can leave application dependency chains disconnected. In this situation, replication health measures data movement, not complete recovered service usability.
Question 391
Two Hyper-V hosts are in separate untrusted forests but the team configures Kerberos-based HTTP replication without a trust relationship. What would be the most defensible next action based on the observed symptoms?
- Configure supported certificate-based HTTPS replication with trusted peer certificates.
- Open TCP 443 on the receiver while leaving both Hyper-V hosts configured for Kerberos HTTP replication with no trusted certificates.
- Enable and configure replication on the new VM individually.
- Narrow allowed replication server/VM scope and certificate trust to the approved source.
Explanation
Correct Answer
A:Kerberos replication assumes suitable AD trust; certificate authentication supports untrusted hosts and encryption. The targeted remedy is to configure supported certificate-based HTTPS replication with trusted peer certificates.
Incorrect Answers
B:Network reachability on port 443 does not create a mutually authenticated HTTPS Replica relationship. Separate untrusted forests cannot satisfy the chosen Kerberos trust prerequisite, so certificate-based configuration is needed on both endpoints.
C:Hyper-V Replica protects selected VMs, not every workload automatically by virtue of host settings. However, Kerberos replication assumes suitable AD trust; certificate authentication supports untrusted hosts and encryption.
D:Replica authorization settings constrain which peers may place copied workloads at the target. Here, Kerberos replication assumes suitable AD trust; certificate authentication supports untrusted hosts and encryption.
Question 392
A Hyper-V Replica host reports certificate validation failure because the receiver's TLS certificate lacks Server Authentication EKU. Which administrative change most directly resolves the documented failure?
- Narrow allowed replication server/VM scope and certificate trust to the approved source.
- Replace it with a certificate containing required Server and Client Authentication uses and a valid trust chain.
- Use a certificate with a subject/SAN matching the Hyper-V Replica Broker's advertised FQDN.
- Configure the Replica Broker role and its appropriate name/authentication settings.
Explanation
Correct Answer
B:Replace it with a certificate containing required Server and Client Authentication uses and a valid trust chain. This addresses the condition because replica HTTPS authentication validates certificate usages and identities before replication starts.
Incorrect Answers
A:Replica authorization settings constrain which peers may place copied workloads at the target. In this situation, replica HTTPS authentication validates certificate usages and identities before replication starts.
C:Replication endpoint name validation must match the broker identity used by the sender. Here, replica HTTPS authentication validates certificate usages and identities before replication starts.
D:Broker identity provides a stable replication endpoint for cluster-owned replicated VMs. In this situation, replica HTTPS authentication validates certificate usages and identities before replication starts.
Question 393
The receiver's certificate was issued for its node FQDN but replication targets a clustered Replica Broker name. Which implementation step directly corrects the underlying problem?
- Configure the Replica Broker role and its appropriate name/authentication settings.
- Enable and authorize the target as a Hyper-V Replica server with its supported authentication configuration.
- Use a certificate with a subject/SAN matching the Hyper-V Replica Broker's advertised FQDN.
- Permit the authorized replication port/protocol between the approved source and broker.
Explanation
Correct Answer
C:Replication endpoint name validation must match the broker identity used by the sender. For that reason, use a certificate with a subject/SAN matching the Hyper-V Replica Broker's advertised FQDN.
Incorrect Answers
A:Broker identity provides a stable replication endpoint for cluster-owned replicated VMs. However, replication endpoint name validation must match the broker identity used by the sender.
B:Source-side replication settings cannot substitute for a receiver accepting replication. Here, replication endpoint name validation must match the broker identity used by the sender.
D:DNS and certificates do not establish a transport path through blocked network filtering. However, replication endpoint name validation must match the broker identity used by the sender.
Question 394
A Hyper-V replication target has suitable storage but the receiving service is not enabled on its host. Which supported action should be taken for this reported condition?
- Use a certificate with a subject/SAN matching the Hyper-V Replica Broker's advertised FQDN.
- Configure the Replica Broker role and its appropriate name/authentication settings.
- Allocate sufficient supported destination storage before starting the initial replica synchronization.
- Enable and authorize the target as a Hyper-V Replica server with its supported authentication configuration.
Explanation
Correct Answer
D:Enable and authorize the target as a Hyper-V Replica server with its supported authentication configuration. The underlying technical reason is that source-side replication settings cannot substitute for a receiver accepting replication.
Incorrect Answers
A:Replication endpoint name validation must match the broker identity used by the sender. Here, source-side replication settings cannot substitute for a receiver accepting replication.
B:Broker identity provides a stable replication endpoint for cluster-owned replicated VMs. In this situation, source-side replication settings cannot substitute for a receiver accepting replication.
C:Replication capacity includes configuration files, VM disks and retained recovery points. However, source-side replication settings cannot substitute for a receiver accepting replication.
Question 395
A clustered destination has no Hyper-V Replica Broker role, so source VMs cannot identify a stable receiving endpoint. Which implementation step directly corrects the underlying problem?
- Configure the Replica Broker role and its appropriate name/authentication settings.
- Use a certificate with a subject/SAN matching the Hyper-V Replica Broker's advertised FQDN.
- Permit the authorized replication port/protocol between the approved source and broker.
- Enable and authorize the target as a Hyper-V Replica server with its supported authentication configuration.
Explanation
Correct Answer
A:Broker identity provides a stable replication endpoint for cluster-owned replicated VMs. A suitable corrective action is to configure the Replica Broker role and its appropriate name/authentication settings.
Incorrect Answers
B:Replication endpoint name validation must match the broker identity used by the sender. However, broker identity provides a stable replication endpoint for cluster-owned replicated VMs.
C:DNS and certificates do not establish a transport path through blocked network filtering. Here, broker identity provides a stable replication endpoint for cluster-owned replicated VMs.
D:Source-side replication settings cannot substitute for a receiver accepting replication. In this situation, broker identity provides a stable replication endpoint for cluster-owned replicated VMs.
Question 396
One Hyper-V VM replicates successfully but a new VM is not protected even though it runs on the same host. What should the administrator change first to correct this specific issue?
- Narrow allowed replication server/VM scope and certificate trust to the approved source.
- Enable and configure replication on the new VM individually.
- Enable and authorize the target as a Hyper-V Replica server with its supported authentication configuration.
- Configure supported certificate-based HTTPS replication with trusted peer certificates.
Explanation
Correct Answer
B:Hyper-V Replica protects selected VMs, not every workload automatically by virtue of host settings. The targeted remedy is to enable and configure replication on the new VM individually.
Incorrect Answers
A:Replica authorization settings constrain which peers may place copied workloads at the target. However, Hyper-V Replica protects selected VMs, not every workload automatically by virtue of host settings.
C:Source-side replication settings cannot substitute for a receiver accepting replication. In this situation, Hyper-V Replica protects selected VMs, not every workload automatically by virtue of host settings.
D:Kerberos replication assumes suitable AD trust; certificate authentication supports untrusted hosts and encryption. However, Hyper-V Replica protects selected VMs, not every workload automatically by virtue of host settings.
Question 397
A remote receiver allows connections from any sender and any VM while administrators require only one authorized source host. What would be the most defensible next action based on the observed symptoms?
- Permit the authorized replication port/protocol between the approved source and broker.
- Replace it with a certificate containing required Server and Client Authentication uses and a valid trust chain.
- Narrow allowed replication server/VM scope and certificate trust to the approved source.
- Enable and configure replication on the new VM individually.
Explanation
Correct Answer
C:Narrow allowed replication server/VM scope and certificate trust to the approved source. This addresses the condition because replica authorization settings constrain which peers may place copied workloads at the target.
Incorrect Answers
A:DNS and certificates do not establish a transport path through blocked network filtering. Here, replica authorization settings constrain which peers may place copied workloads at the target.
B:Replica HTTPS authentication validates certificate usages and identities before replication starts. In this situation, replica authorization settings constrain which peers may place copied workloads at the target.
D:Hyper-V Replica protects selected VMs, not every workload automatically by virtue of host settings. Here, replica authorization settings constrain which peers may place copied workloads at the target.
Question 398
A receiving Hyper-V host has no available space for VM disks plus recovery points, and initial replication repeatedly fails. Which configuration or recovery action best matches this evidence?
- Enable and authorize the target as a Hyper-V Replica server with its supported authentication configuration.
- Configure the Replica Broker role and its appropriate name/authentication settings.
- Use a certificate with a subject/SAN matching the Hyper-V Replica Broker's advertised FQDN.
- Allocate sufficient supported destination storage before starting the initial replica synchronization.
Explanation
Correct Answer
D:Replication capacity includes configuration files, VM disks and retained recovery points. For that reason, allocate sufficient supported destination storage before starting the initial replica synchronization.
Incorrect Answers
A:Source-side replication settings cannot substitute for a receiver accepting replication. In this situation, replication capacity includes configuration files, VM disks and retained recovery points.
B:Broker identity provides a stable replication endpoint for cluster-owned replicated VMs. However, replication capacity includes configuration files, VM disks and retained recovery points.
C:Replication endpoint name validation must match the broker identity used by the sender. Here, replication capacity includes configuration files, VM disks and retained recovery points.
Question 399
A security team wants encrypted Hyper-V Replica traffic across separate sites but selects HTTP Kerberos because domains are trusted. Which Windows Server or Azure operation best addresses the reported fault?
- Use the supported HTTPS certificate-based replication mode to encrypt the replication channel.
- Continue Kerberos-authenticated HTTP replication because the hosts trust each other, assuming domain trust also encrypts the transferred replica data.
- Permit the authorized replication port/protocol between the approved source and broker.
- Replace it with a certificate containing required Server and Client Authentication uses and a valid trust chain.
Explanation
Correct Answer
A:Use the supported HTTPS certificate-based replication mode to encrypt the replication channel. The underlying technical reason is that kerberos over HTTP does not itself provide the TLS transport protection demanded by the requirement.
Incorrect Answers
B:Domain trust makes Kerberos authentication possible, but the selected HTTP mode does not provide the requested HTTPS data-channel encryption. Certificate-based HTTPS replication is required for the stated confidentiality requirement.
C:DNS and certificates do not establish a transport path through blocked network filtering. In this situation, Kerberos over HTTP does not itself provide the TLS transport protection demanded by the requirement.
D:Replica HTTPS authentication validates certificate usages and identities before replication starts. However, Kerberos over HTTP does not itself provide the TLS transport protection demanded by the requirement.
Question 400
A Hyper-V Replica cluster can resolve the broker name but a perimeter firewall blocks the receiver port. What would be the most defensible next action based on the observed symptoms?
- Narrow allowed replication server/VM scope and certificate trust to the approved source.
- Permit the authorized replication port/protocol between the approved source and broker.
- Configure the Replica Broker role and its appropriate name/authentication settings.
- Use a certificate with a subject/SAN matching the Hyper-V Replica Broker's advertised FQDN.
Explanation
Correct Answer
B:DNS and certificates do not establish a transport path through blocked network filtering. A suitable corrective action is to permit the authorized replication port/protocol between the approved source and broker.
Incorrect Answers
A:Replica authorization settings constrain which peers may place copied workloads at the target. However, DNS and certificates do not establish a transport path through blocked network filtering.
C:Broker identity provides a stable replication endpoint for cluster-owned replicated VMs. In this situation, DNS and certificates do not establish a transport path through blocked network filtering.
D:Replication endpoint name validation must match the broker identity used by the sender. However, DNS and certificates do not establish a transport path through blocked network filtering.
Configuring Windows Server Hybrid Advanced Services (AZ-801) Practice Tests