100% Latest & Updated Network Appliance NS0-165 Practice Test Questions, Exam Dumps & Verified Answers!
30 Days Free Updates, Instant Download!
Question 480
A replication fabric changes MTU on the controller but not on a transit switch, causing unexpected throughput drops. Choose TWO measures that together implement and verify a suitable solution for this ONTAP storage-administration situation. (Choose TWO.)
- Align MTU settings end to end across ONTAP interfaces, switch ports, and clients for networks using jumbo frames.
- Document application quiescence or consistency requirements in recurring snapshot runbooks.
- Exercise a controlled controller takeover and verify host I/O continuity, path states and recovery time.
- Configure ONTAP VLAN interfaces with matching switch trunk permissions and client subnet design.
- Test path MTU and sustained large I/O while inspecting drops and fragmentation counters on every affected hop.
Explanation
Correct Answers
A:Align MTU settings end to end across ONTAP interfaces, switch ports, and clients for networks using jumbo frames. A packet larger than any unsupported hop's MTU can fail even when basic network reachability looks normal. Partial jumbo-frame configuration can produce intermittent protocol stalls and poor replication throughput.
E:Test path MTU and sustained large I/O while inspecting drops and fragmentation counters on every affected hop. A packet larger than any unsupported hop's MTU can fail even when basic network reachability looks normal.
Incorrect Answers
B:Document application quiescence or consistency requirements in recurring snapshot runbooks. It tests snapshot copies as recoverable consistency points, not mtu inconsistency and jumbo-frame packet loss.
C:Exercise a controlled controller takeover and verify host I/O continuity, path states and recovery time. It tests host alua and multipath failover under takeover, not mtu inconsistency and jumbo-frame packet loss.
D:Configure ONTAP VLAN interfaces with matching switch trunk permissions and client subnet design. A packet larger than any unsupported hop's MTU can fail even when basic network reachability looks normal.
Question 481
A remote cluster peer stays disconnected after a firewall team limits traffic without checking intercluster LIF sources. Which design choice most directly meets the stated requirement?
- Separate supported cluster, node-management, SVM-management, and data traffic roles according to NetApp topology guidance.
- Check intercluster LIFs, routing, name resolution and required peer ports using the exact source and destination data path.
- Configure supported IPspaces to separate routing and broadcast domains for overlapping or isolated tenant networks.
- Configure ONTAP routes and gateways per IPspace and intended management, data, or replication interfaces.
Explanation
Correct Answer
B:Check intercluster LIFs, routing, name resolution and required peer ports using the exact source and destination data path. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access. An unchecked replication path can silently leave disaster recovery relationships unable to update.
Incorrect Answers
A:Separate supported cluster, node-management, SVM-management, and data traffic roles according to NetApp topology guidance. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
C:Configure supported IPspaces to separate routing and broadcast domains for overlapping or isolated tenant networks. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
D:Configure ONTAP routes and gateways per IPspace and intended management, data, or replication interfaces. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
Question 482
A remote cluster peer stays disconnected after a firewall team limits traffic without checking intercluster LIF sources. Which evidence would BEST validate the intended outcome?
- Inspect LIF roles and network port assignments while measuring representative management and data connectivity.
- Check LACP state, member health, traffic balance, and connectivity after a controlled member failure.
- Test bidirectional intercluster connectivity and verify peer health rather than testing only management addresses.
- Inspect interface tags and switch-port configuration and test end-to-end connectivity using the intended VLAN.
Explanation
Correct Answer
C:Test bidirectional intercluster connectivity and verify peer health rather than testing only management addresses. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
Incorrect Answers
A:Inspect LIF roles and network port assignments while measuring representative management and data connectivity.
B:Check LACP state, member health, traffic balance, and connectivity after a controlled member failure. It tests interface groups and resilient ethernet uplinks, not intercluster lif reachability and peer troubleshooting.
D:Inspect interface tags and switch-port configuration and test end-to-end connectivity using the intended VLAN. It tests vlan interfaces for shared physical uplinks, not intercluster lif reachability and peer troubleshooting.
Question 483
A remote cluster peer stays disconnected after a firewall team limits traffic without checking intercluster LIF sources. What is the principal technical reason for the problem?
- ONTAP uses distinct network traffic classes whose failure domains and performance needs are not interchangeable.
- Link aggregation behavior depends on matching switch and controller modes and does not guarantee one flow uses all links.
- Broadcast domains group ONTAP ports with shared network reachability; incorrect grouping invalidates LIF mobility assumptions.
- Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
Explanation
Correct Answer
D:Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access. An unchecked replication path can silently leave disaster recovery relationships unable to update.
Incorrect Answers
A:ONTAP uses distinct network traffic classes whose failure domains and performance needs are not interchangeable. This explains dedicated cluster and management network roles; it does not describe the limiting mechanism in intercluster lif reachability and peer troubleshooting presented by the scenario.
B:Link aggregation behavior depends on matching switch and controller modes and does not guarantee one flow uses all links. This explains interface groups and resilient ethernet uplinks; it does not describe the limiting mechanism in intercluster lif reachability and peer troubleshooting presented by the scenario.
C:Broadcast domains group ONTAP ports with shared network reachability; incorrect grouping invalidates LIF mobility assumptions. This explains broadcast domains and lif failover targets; it does not describe the limiting mechanism in intercluster lif reachability and peer troubleshooting presented by the scenario.
Question 484
A remote cluster peer stays disconnected after a firewall team limits traffic without checking intercluster LIF sources. Which ongoing practice would BEST prevent recurrence?
- Revalidate site-to-site routes and firewall permits when adding replication targets or IPspaces.
- Keep peer connectivity acceptance tests in site change and firewall review procedures.
- Review IPspace membership and routing boundaries whenever new SVMs or tenant networks are added.
- Retest broadcast domain reachability after switch reconfiguration or cable moves.
Explanation
Correct Answer
B:Keep peer connectivity acceptance tests in site change and firewall review procedures. An unchecked replication path can silently leave disaster recovery relationships unable to update.
Incorrect Answers
A:Revalidate site-to-site routes and firewall permits when adding replication targets or IPspaces. It tests route tables and intercluster replication paths, not intercluster lif reachability and peer troubleshooting.
C:Review IPspace membership and routing boundaries whenever new SVMs or tenant networks are added. It tests ontap ipspaces and tenant routing separation, not intercluster lif reachability and peer troubleshooting.
D:Retest broadcast domain reachability after switch reconfiguration or cable moves. It tests broadcast domains and lif failover targets, not intercluster lif reachability and peer troubleshooting.
Question 485
A remote cluster peer stays disconnected after a firewall team limits traffic without checking intercluster LIF sources. What failure consequence should the organization prioritize?
- An unchecked replication path can silently leave disaster recovery relationships unable to update.
- An invalid interface group can drop clients or leave expensive network ports idle.
- A LIF may fail over to a physically healthy but unreachable port, causing client outage.
- A VLAN mismatch can silently isolate client data services while physical link LEDs remain green.
Explanation
Correct Answer
A:An unchecked replication path can silently leave disaster recovery relationships unable to update. This is a directly relevant trust, availability, cost, privacy, or data-quality consequence of intercluster lif reachability and peer troubleshooting. Underlying mechanism: Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
Incorrect Answers
B:An invalid interface group can drop clients or leave expensive network ports idle.
C:A LIF may fail over to a physically healthy but unreachable port, causing client outage.
D:A VLAN mismatch can silently isolate client data services while physical link LEDs remain green. It tests vlan interfaces for shared physical uplinks, not intercluster lif reachability and peer troubleshooting and produces a different.
Question 486
SnapMirror initialization stalls even though both sites' management IP addresses answer ping. Which change should the team prioritize for this specific ONTAP workload?
- Configure ONTAP routes and gateways per IPspace and intended management, data, or replication interfaces.
- Check intercluster LIFs, routing, name resolution and required peer ports using the exact source and destination data path.
- Separate supported cluster, node-management, SVM-management, and data traffic roles according to NetApp topology guidance.
- Configure supported IPspaces to separate routing and broadcast domains for overlapping or isolated tenant networks.
Explanation
Correct Answer
B:Check intercluster LIFs, routing, name resolution and required peer ports using the exact source and destination data path. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access. An unchecked replication path can silently leave disaster recovery relationships unable to update.
Incorrect Answers
A:Configure ONTAP routes and gateways per IPspace and intended management, data, or replication interfaces. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
C:Separate supported cluster, node-management, SVM-management, and data traffic roles according to NetApp topology guidance. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
D:Configure supported IPspaces to separate routing and broadcast domains for overlapping or isolated tenant networks. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
Question 487
SnapMirror initialization stalls even though both sites' management IP addresses answer ping. Which test would most directly confirm the solution?
- Inspect interface tags and switch-port configuration and test end-to-end connectivity using the intended VLAN.
- Check LACP state, member health, traffic balance, and connectivity after a controlled member failure.
- Inspect LIF roles and network port assignments while measuring representative management and data connectivity.
- Test bidirectional intercluster connectivity and verify peer health rather than testing only management addresses.
Explanation
Correct Answer
D:Test bidirectional intercluster connectivity and verify peer health rather than testing only management addresses. Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
Incorrect Answers
A:Inspect interface tags and switch-port configuration and test end-to-end connectivity using the intended VLAN. It tests vlan interfaces for shared physical uplinks, not intercluster lif reachability and peer troubleshooting.
B:Check LACP state, member health, traffic balance, and connectivity after a controlled member failure. It tests interface groups and resilient ethernet uplinks, not intercluster lif reachability and peer troubleshooting.
C:Inspect LIF roles and network port assignments while measuring representative management and data connectivity.
Question 488
SnapMirror initialization stalls even though both sites' management IP addresses answer ping. Why is the original assumption unreliable?
- Storage network connections need valid forward and return paths in the correct routing context.
- Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
- Link aggregation behavior depends on matching switch and controller modes and does not guarantee one flow uses all links.
- ONTAP uses distinct network traffic classes whose failure domains and performance needs are not interchangeable.
Explanation
Correct Answer
B:Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access. An unchecked replication path can silently leave disaster recovery relationships unable to update.
Incorrect Answers
A:Storage network connections need valid forward and return paths in the correct routing context. This explains route tables and intercluster replication paths; it does not describe the limiting mechanism in intercluster lif reachability and peer troubleshooting presented by the scenario.
C:Link aggregation behavior depends on matching switch and controller modes and does not guarantee one flow uses all links. This explains interface groups and resilient ethernet uplinks; it does not describe the limiting mechanism in intercluster lif reachability and peer troubleshooting presented by the scenario.
D:ONTAP uses distinct network traffic classes whose failure domains and performance needs are not interchangeable. This explains dedicated cluster and management network roles; it does not describe the limiting mechanism in intercluster lif reachability and peer troubleshooting presented by the scenario.
Question 489
SnapMirror initialization stalls even though both sites' management IP addresses answer ping. Which ongoing practice would BEST prevent recurrence?
- Revalidate site-to-site routes and firewall permits when adding replication targets or IPspaces.
- Retest broadcast domain reachability after switch reconfiguration or cable moves.
- Review IPspace membership and routing boundaries whenever new SVMs or tenant networks are added.
- Keep peer connectivity acceptance tests in site change and firewall review procedures.
Explanation
Correct Answer
D:Keep peer connectivity acceptance tests in site change and firewall review procedures. An unchecked replication path can silently leave disaster recovery relationships unable to update.
Incorrect Answers
A:Revalidate site-to-site routes and firewall permits when adding replication targets or IPspaces. It tests route tables and intercluster replication paths, not intercluster lif reachability and peer troubleshooting.
B:Retest broadcast domain reachability after switch reconfiguration or cable moves. It tests broadcast domains and lif failover targets, not intercluster lif reachability and peer troubleshooting.
C:Review IPspace membership and routing boundaries whenever new SVMs or tenant networks are added. It tests ontap ipspaces and tenant routing separation, not intercluster lif reachability and peer troubleshooting.
Question 490
SnapMirror initialization stalls even though both sites' management IP addresses answer ping. What failure consequence should the organization prioritize?
- Incorrect IPspace design can route client traffic to the wrong tenant or prevent access entirely.
- An invalid interface group can drop clients or leave expensive network ports idle.
- A LIF may fail over to a physically healthy but unreachable port, causing client outage.
- An unchecked replication path can silently leave disaster recovery relationships unable to update.
Explanation
Correct Answer
D:An unchecked replication path can silently leave disaster recovery relationships unable to update. This is a directly relevant trust, availability, cost, privacy, or data-quality consequence of intercluster lif reachability and peer troubleshooting. Underlying mechanism: Replication traffic commonly uses dedicated intercluster interfaces and policies separate from management access.
Incorrect Answers
A:Incorrect IPspace design can route client traffic to the wrong tenant or prevent access entirely.
B:An invalid interface group can drop clients or leave expensive network ports idle.
C:A LIF may fail over to a physically healthy but unreachable port, causing client outage.
NetApp Certified Data Administrator, ONTAP (NS0-165) Practice Tests